Nl82011 driver intialization failed

[Nithin Chakravarthi]

Hi,

I am using hostapd 2-2 version in my all winner A20 cubieboard running on
ubuntu 12.04. I have compile the source  code. i t has compiled with out
error. but when i run this is the log

{"
                     1



































*414649556.126296: nl80211: Could not add multicast membership for vendor
events: -2 (No such file or directory)1414649556.126813: rfkill: initial
event: idx=0 type=2 op=0 soft=0 hard=01414649556.126917: rfkill: initial
event: idx=1 type=1 op=0 soft=0 hard=01414649556.126997: rfkill: initial
event: idx=2 type=1 op=0 soft=0 hard=01414649556.128435: nl80211: Supported
cipher 00-0f-ac:11414649556.128623: nl80211: Supported cipher
00-0f-ac:51414649556.128693: nl80211: Supported cipher
00-0f-ac:21414649556.128761: nl80211: Supported cipher
00-0f-ac:41414649556.129151: nl80211: Supported cipher
00-0f-ac:61414649556.129224: nl80211: Using driver-based off-channel
TX1414649556.129364: nl80211: Disable use_monitor with device_ap_sme since
no monitor mode support detected1414649556.129483: nl80211: interface wlan1
in phy phy01414649556.129840: nl80211: Set mode ifindex 5 iftype 3
(AP)1414649556.130097: nl80211: Setup AP(wlan1) - device_ap_sme=1
use_monitor=01414649556.130295: nl80211: Subscribe to mgmt frames with AP
handle 0xf16410 (device SME)1414649556.130384: nl80211: Register frame
type=0xd0 nl_handle=0xf16410 match=1414649556.130613: nl80211: Register
frame command failed (type=208): ret=-114 (Operation already in
progress)1414649556.130700: nl80211: Register frame match - hexdump(len=0):
[NULL]1414649556.130890: nl80211: Could not configure driver
mode1414649556.130963: nl80211: Remove monitor interface:
refcount=01414649556.131036: nl80211: Remove beacon
(ifindex=5)1414649556.131266: netlink: Operstate: ifindex=5 linkmode=0
(kernel-control), operstate=6 (IF_OPER_UP)1414649556.131475: nl80211: Set
mode ifindex 5 iftype 2 (STATION)1414649556.131699: nl80211: Teardown
AP(wlan1) - device_ap_sme=1 use_monitor=01414649556.131794: nl80211 driver
initialization failed.1414649556.131894:
hostapd_interface_deinit_free(0xf15298)1414649556.132007:
hostapd_interface_deinit_free: num_bss=1 conf->num_bss=11414649556.132076:
hostapd_interface_deinit(0xf15298)1414649556.132137: hostapd_bss_deinit:
deinit bss wlan11414649556.132249: hostapd_cleanup(hapd=0xf15de8
(wlan1))1414649556.132332: hostapd_free_hapd_data: Interface wlan1 wasn't
started1414649556.132395: hostapd_interface_deinit_free: driver=(nil)
drv_priv=(nil) -> hapd_deinit1414649556.132465:
hostapd_interface_free(0xf15298)1414649556.132523: hostapd_interface_free:
free hapd 0xf15de81414649556.132587:
hostapd_cleanup_iface(0xf15298)1414649556.132646:
hostapd_cleanup_iface_partial(0xf15298)1414649556.132753:
hostapd_cleanup_iface: free iface=0xf15298*
"}
This is config file
"




















*# WiFi Hotspotinterface=wlan1driver=nl80211#Access
Pointssid=myhotspothw_mode=g# WiFi
Channel:channel=1logger_syslog=-1logger_syslog_level=2logger_stdout=-1logger_stdout_level=2#macaddr_acl=0#auth_algs=1#ignore_broadcast_ssid=0#wpa=3#wpa_passphrase=qwerty0987#wpa_key_mgmt=WPA-PSK#wpa_pairwise=TKIP#rsn_pairwise=CCMP"*
so please any one help me to make board as wifi hotspot



-- 




With Regards,
M.Nithin Chakravrthi
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.shmoo.com/pipermail/hostap/attachments/20141030/1da4e51f/attachment.htm>