[PATCH v3] mesh: Display sae_group to result of status command

[Masashi Honma]

On 2014?12?15? 03:12, Jouni Malinen wrote:
> This would print out the sae_group that the first STA entry in
> SAE_ACCEPTED state happened to use. That may not match what other STAs
> used.
>   
> I'm not sure it really makes much sense to try to have a single
> sae_group entry in the STATUS output for mesh, just like there is not
> much point in trying to do that in AP mode. And if a single value is
> needed, that should really come from the local configuration and not the
> peer entry.
Yes.
I had misunderstood that all STA has same Finite Cyclic Group.
>
> If the negotiated SAE group needs to be exposed through control
> interface for mesh cases, this should be done through some per-STA
> means. I think I'll extend mesh to support the existing STA control
> interface command since that is a trivial change and can provide other
> additional benefits as well (like TX/RX packets/bytes statistics).
>
Thank you.