[PATCH 5/8] WPS: Select only correct AP following provisioning

[Jouni Malinen]

On Thu, Dec 19, 2013 at 12:03:27PM +0200, Arik Nemtsov wrote:
> If there are other saved enabled networks a scan following
> a successful WPS provisioing may connect to one of those
> instead of the AP with which the provisioning was just done.
> Avoid that by allowing only selection of a scan result with
> a matching bssid to the WPS AP. This will be limited to a number
> of scans following WPS provisioing using the same counter
> wpa_s->after_wps used to optimize scan frequency post provisioning.

Are you trying to address selection of the same BSS here? Different
networks (SSID) should already be handled by other network blocks
getting disabled temporarily. I'm not sure that I would agree with the
connection having to be with the same BSS, though, so I would like to
understand why this change would be needed.

-- 
Jouni Malinen                                            PGP id EFC895FA