[PATCH 6/6] P2P: update listen and operating channel from p2p dbus

Jouni Malinen j
Sat Jun 25 02:11:49 PDT 2011

On Thu, Jun 09, 2011 at 04:41:05PM +0000, Sane, Jayant wrote:
> Some P2PDevice properties were not updated in p2p->cfg structure :
> reg_class ,channel , op_reg_class and op_channel.
> Hence,  Update p2p->cfg parameters through p2p core calls in wpas_p2p_update_config
> function.

Thanks, applied. However, I would like to point out that these
configuration parameters are not really meant for normal use and it
would be interesting to hear what kind of use case you are planning for
them. In general, I would recommend leaving these unconfigured and allow
wpa_supplicant to take care of selecting the Listen channel and
operating channel based on network conditions. If a specific operating
channel is desired, that should be configured as an argument to group
formation/addition rather than with this global parameter.

Jouni Malinen                                            PGP id EFC895FA

More information about the Hostap mailing list