hostapd for wired Ethernet: Not receiving EAPOL packets..
Harshil Anil Kumar Shah
Tue Jan 18 04:27:57 PST 2011
I want to run EAP-TLS on wired network using cisco 2960G switch.
Earlier, It was working successfully.
But suddenly, it stopped working
i.e. When I start wpa_supplicant, it shows "Associated with 01:80:c2:00:00:03" then halts for sometimes and stops saying "CTRL-EVENT-EAP-FAILURE EAP authentication failed".
This is my wpa_supplicant.conf,
ctrl_interface =/ var /run / wpa_supplicant
key_mgmt = IEEE8021X
eap = TLS
anonymous_identity =" anonymous at example .com"
password ="whatever "
ca_cert ="/ etc / cert /ca.pem "
I visited couple of forums, I found that entry in /proc/net/dev_mcast needs to be verified :
4 eth0 1 0 0180c2000003
Which is missing in my case.
So should I just add this line to it and test?
Thanks in advance.
Thanks and Regards,
Harshil A. Shah,
Convergence Labs, SETLabs
Infosys Technologies Limited | Bangalore
Mob # : +91 97428 87966.
**************** CAUTION - Disclaimer *****************
This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended solely
for the use of the addressee(s). If you are not the intended recipient, please
notify the sender by e-mail and delete the original message. Further, you are not
to copy, disclose, or distribute this e-mail or its contents to any other person and
any such actions are unlawful. This e-mail may contain viruses. Infosys has taken
every reasonable precaution to minimize this risk, but is not liable for any damage
you may sustain as a result of any virus in this e-mail. You should carry out your
own virus checks before opening the e-mail or attachment. Infosys reserves the
right to monitor and review the content of all messages sent to or from this e-mail
address. Messages sent to or from this e-mail address may be stored on the
Infosys e-mail system.
***INFOSYS******** End of Disclaimer ********INFOSYS***
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Hostap