help needed in pre-authentication

Harshil Anil Kumar Shah Harshil_Shah
Thu Jan 6 20:49:24 PST 2011


I want to perform EAP-TLS pre-authentication. I have setup following test bed.

(Mobile)              wireless               (Current AP) --------------- wired ----------------- (Next AP) -------------------- wired ----------------- (AAA server)                                                                                                                                                         

I have configured the radius IP on Next AP. But what configuration I have to do on Current AP so that It can recognize that request coming from mobile as an EAP request and forwards it to next AP.

Current setup:

Current AP : Dlink DIR 600 wireless router

Next AP:       Cisco catalyst 2960 G switch.

Thanks in advance.

Thanks and Regards,
Harshil A. Shah,
Convergence Labs, SETLabs
Infosys Technologies Limited | Bangalore
Mob # : +91 97428 87966.

**************** CAUTION - Disclaimer *****************
This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended solely 
for the use of the addressee(s). If you are not the intended recipient, please 
notify the sender by e-mail and delete the original message. Further, you are not 
to copy, disclose, or distribute this e-mail or its contents to any other person and 
any such actions are unlawful. This e-mail may contain viruses. Infosys has taken 
every reasonable precaution to minimize this risk, but is not liable for any damage 
you may sustain as a result of any virus in this e-mail. You should carry out your 
own virus checks before opening the e-mail or attachment. Infosys reserves the 
right to monitor and review the content of all messages sent to or from this e-mail 
address. Messages sent to or from this e-mail address may be stored on the 
Infosys e-mail system.
***INFOSYS******** End of Disclaimer ********INFOSYS***
-------------- next part --------------
An HTML attachment was scrubbed...

More information about the Hostap mailing list