[PATCH] hostapd: Add comment about CONFIG_FULL_DYNAMIC_VLAN to defconfig

[Bjarke Istrup Pedersen]

2010/11/9 Helmut Schaa <helmut.schaa at googlemail.com>:
> Add comment about CONFIG_FULL_DYNAMIC_VLAN to defconfig. By default
> this feature is still disabled.
>
> Signed-off-by: Helmut Schaa <helmut.schaa at googlemail.com>
> ---
> ?hostapd/defconfig | ? ?4 ++++
> ?1 files changed, 4 insertions(+), 0 deletions(-)
>
> diff --git a/hostapd/defconfig b/hostapd/defconfig
> index 3ecb7e3..6e15b78 100644
> --- a/hostapd/defconfig
> +++ b/hostapd/defconfig
> @@ -153,6 +153,10 @@ CONFIG_IPV6=y
> ?# Remove support for VLANs
> ?#CONFIG_NO_VLAN=y
>
> +# Enable support fur fully dynamic VLANs. This enables hostapd to
> +# automatically create bridge and VLAN interfaces if necessary.
> +#CONFIG_FULL_DYNAMIC_VLAN=y
> +
> ?# Remove support for dumping state into a file on SIGUSR1 signal
> ?# This can be used to reduce binary size at the cost of disabling a debugging
> ?# option.
> --
> 1.7.1
>
> _______________________________________________
> HostAP mailing list
> HostAP at lists.shmoo.com
> http://lists.shmoo.com/mailman/listinfo/hostap
>

Minor spelling error - it should be "for" instead of "fur" :-)

/Bjarke