help this poor girl,
jennie susan
jennie_susan
Thu May 8 06:11:02 PDT 2008
hello all,
i am trying to setup an environment where i control access to the network. i have set up an local area network. with a radius server, and a linux node i have to run wpasupplicant client to pass authentication. i am using ubuntu gusty, where network manager takes control of everything... everything works fine.... but i wanted to set (test) my own wpa supplicant, so i disabled the wpa_supplicant. i created a wpa_supplicant conf file with following details
network={
ssid="testnet"
proto=WPA
key_mgmt=WPA-PSK
psk=e7172cf145d9cb8d57bf0a06e2317c80e980a8311e7ac807315703299413debb
}
and my output when i run the wpa_supplicant
jennianand at jennianand:~$ sudo wpa_supplicant -w -Dndiswrapper -iwlan0 -c/etc/wpa_supplicant.conf -dd
Initializing interface 'wlan0' conf '/etc/wpa_supplicant.conf' driver 'ndiswrapper' ctrl_interface 'N/A' bridge 'N/A'
Configuration file '/etc/wpa_supplicant.conf' -> '/etc/wpa_supplicant.conf'
Reading configuration file '/etc/wpa_supplicant.conf'
Line: 1 - start of a new network block
ssid - hexdump_ascii(len=7):
74 65 73 74 6e 65 74 testnet
proto: 0x1
key_mgmt: 0x2
PSK - hexdump(len=32): [REMOVED]
Priority group 0
id=0 ssid='testnet'
Initializing interface (2) 'wlan0'
SIOCGIWRANGE: WE(compiled)=22 WE(source)=18 enc_capa=0xf
capabilities: key_mgmt 0xf enc 0xf
WEXT: Operstate: linkmode=1, operstate=5
Own MAC address: 00:1a:73:98:e4:2a
Driver does not support WPA.
wpa_driver_wext_set_key: alg=0 key_idx=0 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=1 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=2 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=3 set_tx=0 seq_len=0 key_len=0
Setting scan request: 0 sec 100000 usec
Added interface wlan0
RTM_NEWLINK: operstate=0 ifi_flags=0x11043 ([UP][RUNNING][LOWER_UP])
Wireless event: cmd=0x8b06 len=8
RTM_NEWLINK: operstate=0 ifi_flags=0x11003 ([UP][LOWER_UP])
RTM_NEWLINK, IFLA_IFNAME: Interface 'wlan0' added
State: DISCONNECTED -> SCANNING
Starting AP scan (broadcast SSID)
Trying to get current scan results first without requesting a new scan to speed up initial association
Received 222 bytes of scan results (1 BSSes)
Scan results: 1
Selecting BSS from priority group 0
Try to find WPA-enabled AP
0: 00:19:bb:fe:41:13 ssid='aalto' wpa_ie_len=0 rsn_ie_len=0 caps=0x1
skip - no WPA/RSN IE
Try to find non-WPA AP
0: 00:19:bb:fe:41:13 ssid='aalto' wpa_ie_len=0 rsn_ie_len=0 caps=0x1
skip - SSID mismatch
No suitable AP found.
Setting scan request: 0 sec 0 usec
Starting AP scan (broadcast SSID)
Scan requested (ret=0) - scan timeout 5 seconds
Scan timeout - try to get results
Received 960 bytes of scan results (4 BSSes)
Scan results: 4
Selecting BSS from priority group 0
Try to find WPA-enabled AP
0: 00:1e:e5:43:7f:2b ssid='testnet' wpa_ie_len=26 rsn_ie_len=0 caps=0x11
selected based on WPA IE
selected WPA AP 00:1e:e5:43:7f:2b ssid='testnet'
Try to find non-WPA AP
Trying to associate with 00:1e:e5:43:7f:2b (SSID='testnet' freq=2462 MHz)
Cancelling scan request
WPA: clearing own WPA/RSN IE
Automatic auth_alg selection: 0x1
WPA: using IEEE 802.11i/D3.0
WPA: Selected cipher suites: group 8 pairwise 8 key_mgmt 2 proto 1
WPA: set AP WPA IE - hexdump(len=26): dd 18 00 50 f2 01 01 00 00 50 f2 02 01 00 00 50 f2 02 01 00 00 50 f2 02 00 00
WPA: clearing AP RSN IE
WPA: using GTK TKIP
WPA: using PTK TKIP
WPA: using KEY_MGMT WPA-PSK
WPA: Set own WPA IE default - hexdump(len=24): dd 16 00 50 f2 01 01 00 00 50 f2 02 01 00 00 50 f2 02 01 00 00 50 f2 02
No keys have been configured - skip key clearing
State: SCANNING -> ASSOCIATING
wpa_driver_wext_set_operstate: operstate 0->0 (DORMANT)
WEXT: Operstate: linkmode=-1, operstate=5
Association request to the driver failed
Setting authentication timeout: 5 sec 0 usec
Authentication with 00:1e:e5:43:7f:2b timed out.
Added BSSID 00:1e:e5:43:7f:2b into blacklist
No keys have been configured - skip key clearing
State: ASSOCIATING -> DISCONNECTED
wpa_driver_wext_set_operstate: operstate 0->0 (DORMANT)
WEXT: Operstate: linkmode=-1, operstate=5
Setting scan request: 0 sec 0 usec
State: DISCONNECTED -> SCANNING
Starting AP scan (broadcast SSID)
Scan requested (ret=0) - scan timeout 5 seconds
Scan timeout - try to get results
Received 960 bytes of scan results (4 BSSes)
Scan results: 4
Selecting BSS from priority group 0
Try to find WPA-enabled AP
0: 00:1e:e5:43:7f:2b ssid='testnet' wpa_ie_len=26 rsn_ie_len=0 caps=0x11
selected based on WPA IE
selected WPA AP 00:1e:e5:43:7f:2b ssid='testnet'
Try to find non-WPA AP
Trying to associate with 00:1e:e5:43:7f:2b (SSID='testnet' freq=2462 MHz)
Cancelling scan request
WPA: clearing own WPA/RSN IE
Automatic auth_alg selection: 0x1
WPA: using IEEE 802.11i/D3.0
WPA: Selected cipher suites: group 8 pairwise 8 key_mgmt 2 proto 1
WPA: set AP WPA IE - hexdump(len=26): dd 18 00 50 f2 01 01 00 00 50 f2 02 01 00 00 50 f2 02 01 00 00 50 f2 02 00 00
WPA: clearing AP RSN IE
WPA: using GTK TKIP
WPA: using PTK TKIP
WPA: using KEY_MGMT WPA-PSK
WPA: Set own WPA IE default - hexdump(len=24): dd 16 00 50 f2 01 01 00 00 50 f2 02 01 00 00 50 f2 02 01 00 00 50 f2 02
No keys have been configured - skip key clearing
State: SCANNING -> ASSOCIATING
wpa_driver_wext_set_operstate: operstate 0->0 (DORMANT)
WEXT: Operstate: linkmode=-1, operstate=5
Association request to the driver failed
Setting authentication timeout: 5 sec 0 usec
Authentication with 00:1e:e5:43:7f:2b timed out.
BSSID 00:1e:e5:43:7f:2b blacklist count incremented to 2
No keys have been configured - skip key clearing
State: ASSOCIATING -> DISCONNECTED
wpa_driver_wext_set_operstate: operstate 0->0 (DORMANT)
WEXT: Operstate: linkmode=-1, operstate=5
Setting scan request: 0 sec 0 usec
State: DISCONNECTED -> SCANNING
Starting AP scan (broadcast SSID)
Scan requested (ret=0) - scan timeout 5 seconds
CTRL-EVENT-TERMINATING - signal 2 received
Removing interface wlan0
State: SCANNING -> DISCONNECTED
wpa_driver_wext_set_operstate: operstate 0->0 (DORMANT)
WEXT: Operstate: linkmode=-1, operstate=5
No keys have been configured - skip key clearing
Failed to disable WPA in the driver.
No keys have been configured - skip key clearing
Removed BSSID 00:1e:e5:43:7f:2b from blacklist (clear)
Cancelling scan request
Cancelling authentication timeout
WEXT: Operstate: linkmode=0, operstate=6
it say driver doesnot support wpa, but i had been worked with network manager for 2 months without nay problem....
here is my wireless card details
*-network
description: Wireless interface
product: BCM4312 802.11a/b/g
vendor: Broadcom Corporation
physical id: 0
bus info: pci at 0000:03:00.0
logical name: wlan0
version: 02
serial: 00:1a:73:98:e4:2a
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress bus_master cap_list ethernet physical wireless
configuration: broadcast=yes driver=ndiswrapper+bcmwl5 driverversion=1.45+Broadcom,10/12/2006, 4.100. ip=130.233.238.79 latency=0 link=yes module=ndiswrapper multicast=yes wireless=IEEE 802.11g
and here is my dmesg output
[ 18.824000] ndiswrapper version 1.45 loaded (smp=yes)
[ 18.952000] ndiswrapper: driver bcmwl5 (Broadcom,10/12/2006, 4.100.15.5) loaded
[ 18.956000] ACPI: PCI Interrupt Link [LK4E] enabled at IRQ 19
[ 18.956000] ACPI: PCI Interrupt 0000:03:00.0[A] -> Link [LK4E] -> GSI 19 (level, low) -> IRQ 22
[ 18.956000] PCI: Setting latency timer of device 0000:03:00.0 to 64
[ 18.964000] ndiswrapper: using IRQ 22
[ 19.312000] wlan0: ethernet device 00:1a:73:98:e4:2a using NDIS driver: bcmwl5, version: 0x4640f05, NDIS version: 0x501, vendor: '', 14E4:4312.5.conf
[ 19.312000] wlan0: encryption modes supported: WEP; TKIP with WPA, WPA2, WPA2PSK; AES/CCMP with WPA, WPA2, WPA2PSK
here is my ndiswrapper version
jennianand at jennianand:~$ ndiswrapper -v
utils version: 1.9
driver filename: /lib/modules/2.6.22-14-generic/ubuntu/misc/ndiswrapper/ndiswrapper.ko
version: 1.45
vermagic: 2.6.22-14-generic SMP mod_unload 586
jennianand at jennianand:~$ ndiswrapper -l
bcmwl5 : driver installed
device (14E4:4312) present (alternate driver: bcm43xx)
and i already black listed bcm43xx
i have no clue, whats happing, i havnt installed wpa_supplicant myself, it was in my system already.
any help, any hint, will be apperciable.... dont push me to ask ubuntu forum, i have tried everything no luck..... plz help me... i ahve to finish this fo rmy thesis which is due in a week.
thank you for taking time for me,
jreuben
---------------------------------
Be a better friend, newshound, and know-it-all with Yahoo! Mobile. Try it now.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.shmoo.com/pipermail/hostap/attachments/20080508/fc710bb5/attachment.htm
More information about the Hostap
mailing list