prism 2.5 card resets

[Rees]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hi,
I'm running hostap on an ipcop box using the wlanap addon and hostap
drivers and i seem to be having a problem whereby the card (Senao
NL-2511CD Ext2) resets under heavyish traffic load or when there are
more than a couple of clients connected.

At the moment i'm running,
NICID: id=0x800c v1.0.0 (PRISM II (2.5) PCMCIA (SST parallel flash))
PRIID: id=0x0015 v1.1.1
STAID: id=0x001f v1.7.4 (station firmware)

but i've also experienced the problem using 1.8.2 firmware as well.
Dmesg output leading up to the reset is included below.
The only idea i could come up with is that according to /proc/interrupts
the card is sharing an irq with my ethernet card and another pci device
(i'm assuming it's the pcmcia>pci bridge?) Would this be expected to
cause problems?

output of /proc/interrupts;
5:    1459605          XT-PIC  PCI device 1180:0476, hostap_cs, eth0

Dmesg output
wifi0: hfa384x_cmd: entry still in list? (entry=c199dbd0, type=0, res=0)
wifi0: hfa384x_cmd: command was not completed (res=0, entry=c199dbd0,
type=0, cmd=0x0002, param0=0x0000, EVSTAT=0000 INTEN=e09f)
wifi0: reset port failed to disable port
NETDEV WATCHDOG: wifi0: transmit timed out
wifi0 Tx timed out! Resetting card
wifi0: CMD=0002 EVSTAT=0000 OFFSET0=0000 OFFSET1=0000 SWSUPPORT0=8a32
wifi0: scheduled card reset
hostap_cs: wifi0: resetting card
prism2_pccard_cor_sreset: original COR 41
wifi0: removed pending cmd_queue entry (type=1, cmd=0x010b, param0=0x0134)
prism2_hw_init: initialized in 190 ms
wifi0: STA xx:xx:xx:xx:xx:xx TX rate lowered to 55
wifi0: hfa384x_cmd: entry still in list? (entry=c199dc50, type=0, res=0)
wifi0: hfa384x_cmd: command was not completed (res=0, entry=c199dc50,
type=0, cmd=0x0002, param0=0x0000, EVSTAT=0000 INTEN=e09f)
wifi0: reset port failed to disable port
wifi0: hfa384x_cmd: entry still in list? (entry=c199dd10, type=0, res=0)
wifi0: hfa384x_cmd: command was not completed (res=0, entry=c199dd10,
type=0, cmd=0x0021, param0=0xfc28, EVSTAT=0000 INTEN=e09f)
wifi0: hfa384x_get_rid: CMDCODE_ACCESS failed (res=-110, rid=fc28, len=2)
Could not read current WEP flags.
wifi0: encryption setup failed
NETDEV WATCHDOG: wifi0: transmit timed out
wifi0 Tx timed out! Resetting card
wifi0: CMD=0002 EVSTAT=0000 OFFSET0=0000 OFFSET1=0000 SWSUPPORT0=8a32
wifi0: scheduled card reset
hostap_cs: wifi0: resetting card
prism2_pccard_cor_sreset: original COR 41
wifi0: removed pending cmd_queue entry (type=1, cmd=0x0011, param0=0xf100)
wifi0: removed pending cmd_queue entry (type=1, cmd=0x010b, param0=0x015e)
prism2_hw_init: initialized in 190 ms


-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.6 (GNU/Linux)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org

iQEVAwUBSIwV1guPyvlkJ5mnAQIfzgf/bpKwzWGOE0k6uxVoFejALNyJMHONVvOH
gEe1et09zdN+gMiJWtyF+YDBhlrbmi8x5DESsOebMmUSeQweRIKdYlRUo1QpUeOE
yUUYYclOfICC5gU/MvZX6OQKXVh7aDZxpAwvoz+MD4E64pi6yJ5IORwH+sz6ucHO
/kodfmE5kKZbPOVDer9mFVsBKCsXEgXrkmNXSSupqW6zLZYxuelPxKv6YOcx8UdQ
5/QRZPYRBFqUrsWXH2+GGBnJol55NOB111URE44pazhTGwc7qwo2MiBPGA5yJ3jw
FpYEOm+5ssvJwsnCOGzq6U8OuNZUHRHCX5L4AipkP6CjYGeSyZmF+A==
=EUY9
-----END PGP SIGNATURE-----