HOSTAPD not running with CONF File

maloomnahi at indiatimes.com maloomnahi
Mon Sep 10 20:34:06 PDT 2007


Hi Michael,

Yes I am running everything in the root and I have a thread running on the same issue: http://lists.shmoo.com/pipermail/hostap/2007-September/016012.html

Following are the settings in my hostapd.conf / madwifi.conf [i have pruned both to check if any of these works]

interface=eth0
bridge=br0
driver=madwifi
logger_syslog=-1
logger_syslog_level=2
logger_stdout=-1
logger_stdout_level=2
debug=0
ctrl_interface_group=0
ssid="TEST"
hw_mode=g
channel=11
beacon_int=100
max_num_sta=255
rts_threshold=2347
fragm_threshold=2346
macaddr_acl=0
auth_algs=3
ignore_broadcast_ssid=0
ap_max_inactivity=300
bridge_packets=0
eapol_version=1
eap_message=hello
wep_key_len_broadcast=5
wep_key_len_unicast=5
eap_reauth_period=3600
eap_server=1
private_key_passwd=secret passphrase
own_ip_addr=192.168.1.151
wpa=1
wpa_passphrase=secret passphrase
wpa_psk_file=hostapd-0.5.8/hostapd.wpa_psk
wpa_key_mgmt=WPA-PSK
passive_scan_listen=1000
passive_scan_mode=1

It would be great if you could help me out or atleast direct me to someone who could solve the same.

Thanks
PPN


----- Original Message -----
From: michael able <the-able at gmx.net>
To: maloomnahi at indiatimes.com
Sent: Mon, 10 Sep 2007 22:51:44 +0530 (IST)
Subject: Re: HOSTAPD with CONFIG File

Hi Prashant,

sorry, but i can't remember how i solved it. it was a long time ago and
i wasn't doing anything with wlan since then.
if i remember correctly it was something quite simple, something like
missing root-privileges. did you try running it as root?

the selection of the EAP-type and other things is done in the config-file.

Best Regards,
Michael.


maloomnahi at indiatimes.com schrieb:
> Dear Michael,
> 
> This email is with regards to the problem you had faced about hostapd -dd madwifi.conf giving "invalid/unknown driver 'madwifi" error on the prompt. [dated August 02 2006]
> 
> I have read your conversation with Jouni, but what was the ultimate solution to the problem. It would be great if you could solve this problem for me. Please also tell me if running the above command would be enough to start the complete AP or hostapd as such or we need to give commands on the prompt for type of EAP, association etc?
> 
> Looking forward to your reply. For more Information on my setup please see below:
> 
> Hostapd - v0.5.8
> Madwifi - v0.9.3.1
> TPLINK AR5212 Chipset - Only one PCI card on Linux machine
> 
> Thanks
> Prashant
> 


--
My life has changed. What about yours?
Log on to the new Indiatimes Mail and Live out of the Inbox!



More information about the Hostap mailing list