Hostapd gives error with Madwifi.conf file

[maloomnahi at indiatimes.com]

Hi Nazeer,

Following was the result by using the same mentioned conf file

[root at localhost hostapd-0.5.8]# hostapd -dd hostapd1.conf
Configuration file: hostapd1.conf
ctrl_interface_group=0
ioctl(SIOCGIFINDEX): No such device
madwifi driver initialization failed.
eth1: Unable to setup interface.
Flushing old station entries
Deauthenticate all stations
rmdir[ctrl_interface]: No such file or directory

Is the issue with the CONF / CONFIG file or some driver settings? Thanks for everything ... in advance

Regards
PPN


----- Original Message -----
From: Nazeer <nazeer.khan at nicta.com.au>
To: maloomnahi at indiatimes.com
Cc: hostap at shmoo.com
Sent: Mon, 10 Sep 2007 09:20:10 +0530 (IST)
Subject: RE: Hostapd gives error with Madwifi.conf file

Use the following config file and if you have any errors post them here.....

# Configuration File for WPA-PSK
interface=ath0
bridge=br0
driver=madwifi
logger_syslog=-1
logger_syslog_level=2
logger_stdout=-1
logger_stdout_level=2
debug=0
dump_file=/tmp/hostapd.dump
ctrl_interface=/var/run/hostapd
ctrl_interface_group=0
ssid=test_ssid
macaddr_acl=0
auth_algs=3
wpa=3
wpa_passphrase=XXXXXXXXXXX
wpa_key_mgmt=WPA-PSK
wpa_pairwise=TKIP CCMP

-----Original Message-----
From: hostap-bounces+nazeer.khan=nicta.com.au at shmoo.com
[mailto:hostap-bounces+nazeer.khan=nicta.com.au at shmoo.com] On Behalf Of
maloomnahi at indiatimes.com
Sent: Monday, September 10, 2007 1:30 PM
To: Nazeer Khan
Cc: hostap at shmoo.com
Subject: Re: Hostapd gives error with Madwifi.conf file

Hi Nazeer,

Thanks for the information, I had the same setting in my .config file and no
use changing that. Below is the result I am getting now:

[root at localhost hostapd-0.5.8]# hostapd -dd madwifi.conf
Configuration file: madwifi.conf
'ine 14: invalid/unknown driver 'madwifi
'.2 errors found in configuration file 'madwifi.conf'

[root at localhost hostapd-0.5.8]# hostapd -dd hostapd.conf
Configuration file: hostapd.conf
ctrl_interface_group=0
eapol_version=1
ioctl[SIOCSIWMODE]: Operation not supported
Could not set interface to master mode!
madwifi driver initialization failed.
eth0: Unable to setup interface.
Flushing old station entries
Deauthenticate all stations
rmdir[ctrl_interface]: No such file or directory

I am not finding any solution to this as of now, it would be great if you
could give me a solution to this problem. Following are the additional
information. .Config, hostapd.conf are set according to the ticket 539 and
as per lists.shmoo.com.

Madiwfi-0.9.3.1
Linux 2.6.18
Hostapd 0.5.8
AR5212 Chipset

Thanks
PPN


----- Original Message -----
From: Nazeer Khan <Nazeer.Khan at nicta.com.au>
To: maloomnahi at indiatimes.com
Cc: hostap at shmoo.com
Sent: Sat, 8 Sep 2007 06:35:52 +0530 (IST)
Subject: Re: Hostapd gives error with Madwifi.conf file


On Fri, September 7, 2007 5:10 pm, maloomnahi at indiatimes.com said:
> Dear All,
>
> This email is with regards to a problem faced while running the
> hostapdv0.5.8 with madwifi CONFIG file. Its about hostapd -dd madwifi.conf
> giving "Line 14: invalid/unknown driver 'madwifi" error on the prompt.

I believe you have not compiled hostapd with madwifi support. Change the
.config file to include madwifi driver too.

# Driver interface for madwifi driver
CONFIG_DRIVER_MADWIFI=y
CFLAGS += -I/usr/src/madwifi-ng

-- 
Regards,

Nazeer Khan
Research Student
Networks and Pervasive Computing
National ICT Australia Limited
Phone: +61 2 8374 5554
Mobile: +61 415627442

The imagination driving Australia's ICT future.

_______________________________________________
HostAP mailing list
HostAP at shmoo.com
http://lists.shmoo.com/mailman/listinfo/hostap