Supplicant : 8021X-PSK not associating to AP

[Bryan Kadzban]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: RIPEMD160

Mr. Maloomnahi wrote:
> key mgt 8021X-PSK

Huh?  I don't think that's valid.  Either you use 802.1x or you use a
pre-shared key; I'm pretty sure you don't mix them.

Unless this is supposed to be WPA-Enterprise using EAP-PSK?

> Problem Faced: No Association between both. WPA goes to INACTIVE mode
>  after scanning.

See the log lines below:

> Received 335 bytes of scan results (1 BSSes)
> Scan results: 1
> No suitable AP found.
> Setting scan request: 0 sec 0 usec
> No enabled networks - do not scan

It found one AP, but didn't think the AP's beacon (or probe response)
matched any of its networks.  It then failed to scan because no networks
were set up in its config file (or if they were set up, they weren't
enabled).

I assume your config file is valid, right?  Can you post it?
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.7 (GNU/Linux)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org

iD8DBQFHDgScS5vET1Wea5wRA00EAKCcgEyBwV0iBf4YMiiTv/k1cbM7ywCg2XKn
8xgGLcF0UVAT+QkM6HI2RsU=
=h5qG
-----END PGP SIGNATURE-----