prism2_config() failed... (Consulted FAQ's and Mailing archive but still could not resolve)

[Fawad Nazir]

On 5/17/06, Bryan Kadzban <bryan at kadzban.is-a-geek.net> wrote:
> Fawad Nazir wrote:
> > 3. Why the out of dmesg shows the following messages. Is orinoco
> > driver also being tried to load:
> > [4296860.095000] orinoco 0.15rc3 (David Gibson
> > <hermes at gibson.dropbear.id.au>, Pavel Roskin <proski at gnu.org>, et al)
> > [4296860.123000] orinoco_cs 0.15rc3 (David Gibson
> > <hermes at gibson.dropbear.id.au>, Pavel Roskin <proski at gnu.org>, et al)
> > [4296860.127000] pcmcia: registering new device pcmcia0.1
> >
> > I have already blacklisted it. But still it is listed in lsmod command.
>
> It looks like you haven't blacklisted it *correctly*, though; you're
> getting this from modprobe:
>
> > fawad at Ubuntu-01:~$ sudo modprobe hostap_cs ignore_cis_vcc=1
> > WARNING: /etc/modprobe.d/my_blacklist line 1: ignoring bad line
> > starting with 'orinoco_cs'
> > WARNING: /etc/modprobe.d/my_blacklist line 2: ignoring bad line
> > starting with 'orinoco'
>
> Notice how those "bad line"s *start* with orinoco_cs and orinoco.  The
> correct syntax to blacklist those two modules is:
>
> blacklist orinoco_cs
> blacklist orinoco

Thanks, i have done that. Now i dont get these warning, but still the
problems with my hostap_cs driver are there as i mentioned in my
previous email.
Any idea, what could cause the problem?

> and neither of those lines start with orinoco_cs or orinoco.
>
>
>


-- 
Fawad Nazir