How do i know that i am using Host-AP for my PCMCIA Card...

[Fawad Nazir]

Thax a lot for your reply.

Rest of my steps are ok? or i am making any mistake?
Do you recommend that i should -r orinoco_cs from the kernel and then
again restart the machine. Do i also have to make any changes to
/etc/pcmcia/config file?

Best Regards,
Fawad.

On 5/15/06, Jar <jar at pcuf.fi> wrote:
>
> > [17181203.040000] eth0: Hardware identity 800c:0000:0001:0000
> > [17181203.040000] eth0: Station identity  001f:0000:0001:0008
> > [17181203.040000] eth0: Firmware determined as Intersil 1.8.0
> > [17181203.040000] eth0: Ad-hoc demo mode supported
> > [17181203.040000] eth0: IEEE standard IBSS ad-hoc mode supported
> > [17181203.040000] eth0: WEP supported, 104-bit key
> > [17181203.040000] eth0: MAC address 00:02:6F:39:B9:57
> > [17181203.040000] eth0: Station name "Prism  I"
> > [17181203.040000] eth0: ready
> > [17181203.048000] eth0: index 0x01: Vcc 3.3, irq 3, io 0x3100-0x313f
>
> It seems that the orinoco_cs is loaded first and you actually use orinoco driver
> instead of hostap driver. Hostap uses wlanX interface names, orinoco uses ethX.
>
> --
> Best Regards, Jar
> _______________________________________________
> HostAP mailing list
> HostAP at shmoo.com
> http://lists.shmoo.com/mailman/listinfo/hostap
>


-- 
Fawad Nazir