ipw3945, Cisco LEAP
Greg Willden
gregwillden
Thu Dec 21 09:31:37 PST 2006
Hi All,
I'm new to this list and wpa_supplicant.
I am trying to get my laptop's wireless working with my company's Cisco LEAP
APs.
I have ipw3945 with module version 1.0.5m
wpa_supplicant is v0.4.8
$ uname -a
Linux eiger 2.6.15-27-386 #1 PREEMPT Fri Dec 8 17:51:56 UTC 2006 i686
GNU/Linux
So far the following configuration seems to get the closest to working.
Although the auth_alg=LEAP doesn't seem to make any difference.
network={
ssid="ADSWireless"
scan_ssid=1
#key_mgmt=WPA-EAP
key_mgmt=IEEE8021X
auth_alg=LEAP
eap=LEAP
priority=2
proto=WPA
identity="username"
password="password"
}
Here is a dump from wpa_supplicant.
Can you offer any suggestions?
Thanks
Greg
$ sudo wpa_supplicant -ieth1 -Dwext -c/etc/wpa_supplicant.conf -dd
Initializing interface 'eth1' conf '/etc/wpa_supplicant.conf' driver 'wext'
ctrl_interface 'N/A'
Configuration file '/etc/wpa_supplicant.conf' -> '/etc/wpa_supplicant.conf'
Reading configuration file '/etc/wpa_supplicant.conf'
Line: 1 - start of a new network block
ssid - hexdump_ascii(len=11):
41 44 53 57 69 72 65 6c 65 73 73 ADSWireless
scan_ssid=1 (0x1)
key_mgmt: 0x8
auth_alg: 0x4
eap methods - hexdump(len=2): 11 00
priority=2 (0x2)
proto: 0x1
identity - hexdump_ascii(len=8):
67 77 69 6c 6c 64 65 6e gwillden
password - hexdump_ascii(len=8): [REMOVED]
Priority group 2
id=0 ssid='ADSWireless'
Initializing interface (2) 'eth1'
EAPOL: SUPP_PAE entering state DISCONNECTED
EAPOL: KEY_RX entering state NO_KEY_RECEIVE
EAPOL: SUPP_BE entering state INITIALIZE
EAP: EAP entering state DISABLED
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
SIOCGIWRANGE: WE(compiled)=19 WE(source)=16 enc_capa=0xf
capabilities: key_mgmt 0xf enc 0xf
Own MAC address: 00:13:02:b3:3f:d9
wpa_driver_wext_set_wpa
wpa_driver_wext_set_key: alg=0 key_idx=0 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=1 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=2 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=3 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_countermeasures
wpa_driver_wext_set_drop_unencrypted
Setting scan request: 0 sec 100000 usec
Added interface eth1
Wireless event: cmd=0x8b06 len=8
RTM_NEWLINK, IFLA_IFNAME: Interface 'eth1' added
RTM_NEWLINK, IFLA_IFNAME: Interface 'eth1' added
State: DISCONNECTED -> SCANNING
Starting AP scan (specific SSID)
Scan SSID - hexdump_ascii(len=11):
41 44 53 57 69 72 65 6c 65 73 73 ADSWireless
Wireless event: cmd=0x8b15 len=20
Wireless event: new AP: 00:00:00:00:00:00
Added BSSID 00:00:00:00:00:00 into blacklist
State: SCANNING -> DISCONNECTED
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
CTRL-EVENT-DISCONNECTED - Disconnect event - remove keys
wpa_driver_wext_set_key: alg=0 key_idx=0 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=1 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=2 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=3 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=0 set_tx=0 seq_len=0 key_len=0
Scan timeout - try to get results
Received 768 bytes of scan results (4 BSSes)
Scan results: 4
Selecting BSS from priority group 2
0: 00:0d:8d:f0:0b:51 ssid='Weathervane' wpa_ie_len=26 rsn_ie_len=0 caps=0x11
skip - SSID mismatch
1: 00:40:96:a0:c0:80 ssid='ADSWireless' wpa_ie_len=0 rsn_ie_len=0 caps=0x11
skip - no WPA/RSN IE
2: 00:0f:f7:66:4b:f0 ssid='ADSWireless' wpa_ie_len=0 rsn_ie_len=0 caps=0x11
skip - no WPA/RSN IE
3: 00:14:bf:78:4b:b0 ssid='<hidden>' wpa_ie_len=0 rsn_ie_len=0 caps=0x11
skip - no WPA/RSN IE
selected non-WPA AP 00:40:96:a0:c0:80 ssid='ADSWireless'
Trying to associate with 00:40:96:a0:c0:80 (SSID='ADSWireless' freq=0 MHz)
Cancelling scan request
WPA: clearing own WPA/RSN IE
Automatic auth_alg selection: 0x4
Overriding auth_alg selection: 0x4
WPA: clearing AP WPA IE
WPA: clearing AP RSN IE
WPA: clearing own WPA/RSN IE
No keys have been configured - skip key clearing
wpa_driver_wext_set_drop_unencrypted
State: DISCONNECTED -> ASSOCIATING
wpa_driver_wext_associate
Setting authentication timeout: 10 sec 0 usec
EAPOL: External notification - portControl=Auto
Wireless event: cmd=0x8b06 len=8
Wireless event: cmd=0x8b1a len=20
Wireless event: cmd=0x8b15 len=20
Wireless event: new AP: 00:00:00:00:00:00
BSSID 00:00:00:00:00:00 blacklist count incremented to 2
State: ASSOCIATING -> DISCONNECTED
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
CTRL-EVENT-DISCONNECTED - Disconnect event - remove keys
wpa_driver_wext_set_key: alg=0 key_idx=0 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=1 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=2 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=3 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=0 set_tx=0 seq_len=0 key_len=0
Authentication with 00:00:00:00:00:00 timed out.
BSSID 00:00:00:00:00:00 blacklist count incremented to 3
State: DISCONNECTED -> DISCONNECTED
No keys have been configured - skip key clearing
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
Setting scan request: 0 sec 0 usec
State: DISCONNECTED -> SCANNING
Starting AP scan (broadcast SSID)
Scan timeout - try to get results
Received 767 bytes of scan results (4 BSSes)
Scan results: 4
Selecting BSS from priority group 2
0: 00:0d:8d:f0:0b:51 ssid='Weathervane' wpa_ie_len=26 rsn_ie_len=0 caps=0x11
skip - SSID mismatch
1: 00:40:96:a0:c0:80 ssid='ADSWireless' wpa_ie_len=0 rsn_ie_len=0 caps=0x11
skip - no WPA/RSN IE
2: 00:0f:f7:66:4b:f0 ssid='ADSWireless' wpa_ie_len=0 rsn_ie_len=0 caps=0x11
skip - no WPA/RSN IE
3: 00:14:bf:78:4b:b0 ssid='<hidden>' wpa_ie_len=0 rsn_ie_len=0 caps=0x11
skip - no WPA/RSN IE
selected non-WPA AP 00:40:96:a0:c0:80 ssid='ADSWireless'
Trying to associate with 00:40:96:a0:c0:80 (SSID='ADSWireless' freq=0 MHz)
Cancelling scan request
WPA: clearing own WPA/RSN IE
Automatic auth_alg selection: 0x4
Overriding auth_alg selection: 0x4
WPA: clearing AP WPA IE
WPA: clearing AP RSN IE
WPA: clearing own WPA/RSN IE
No keys have been configured - skip key clearing
wpa_driver_wext_set_drop_unencrypted
State: SCANNING -> ASSOCIATING
wpa_driver_wext_associate
Setting authentication timeout: 10 sec 0 usec
EAPOL: External notification - portControl=Auto
Wireless event: cmd=0x8b06 len=8
Wireless event: cmd=0x8b1a len=20
CTRL-EVENT-TERMINATING - signal 2 received
Removing interface eth1
State: ASSOCIATING -> DISCONNECTED
No keys have been configured - skip key clearing
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
wpa_driver_wext_set_wpa
wpa_driver_wext_set_drop_unencrypted
wpa_driver_wext_set_countermeasures
No keys have been configured - skip key clearing
Removed BSSID 00:00:00:00:00:00 from blacklist (clear)
Cancelling scan request
--
Linux. Because rebooting is for adding hardware.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.shmoo.com/pipermail/hostap/attachments/20061221/0b4a65c3/attachment.htm
More information about the Hostap
mailing list