Scanning routine

[Marcin Dabrowski]

>	But is there any routine which is called before scanning has been
>> started ?? For example if there was one, it could be possible to change
>> host_roaming mode to 2 in that routine, do scanning manually, and at
the
>> end restore host_roaming to 1.


>>I'm not aware of any way to get such event from the firmware.

So in host_roaming = 2 I can only test signal quality during data
tramsminssion. Is there any way to influence the channel that are to scan
in host_roaming mode set to 1. How is the scanning done in this mode: by
sending probe requests or analyzing beacons ??

Marcin