0.3.9

[hiphin]

Hi Jouni, hostap 0.3.9 (and wirst case 0.3.7) is problem still ... and as 
Tony say, low bitrate !

what shall we do ? go back to 0.2.6 or forward to 0.4.x ?

look at this lie !!! please
this is from AP-2 in WDS, 00:11:22:33:44:12, and AP-3 00:11:22:33:44:13

dmesg
wifi0: Could not find STA 00:11:22:33:44:11 for this TX error (@5724833)
wifi0: Could not find STA 00:11:22:33:44:11 for this TX error (@5749306)
wifi0: Could not find STA 00:11:22:33:44:11 for this TX error (@5759608)
wifi0: Could not find STA 00:11:22:33:44:11 for this TX error (@5862843)
wifi0: Could not find STA 00:11:22:33:44:11 for this TX error (@5914069)
wifi0: Could not find STA 00:11:22:33:44:11 for this TX error (@6247523)
wifi0: Could not find STA 00:11:22:33:44:11 for this TX error (@6257783)
wifi0: Could not find STA 00:11:22:33:44:11 for this TX error (@6421581)
wifi0: Could not find STA 00:11:22:33:44:11 for this TX error (@6431695)
wifi0: Could not find STA 00:11:22:33:44:11 for this TX error (@6454437)
wifi0: Could not find STA 00:11:22:33:44:11 for this TX error (@6540354)
wifi0: Could not find STA 00:11:22:33:44:11 for this TX error (@6552323)
wifi0: Could not find STA 00:11:22:33:44:11 for this TX error (@6596962)
wifi0: Could not find STA 00:11:22:33:44:11 for this TX error (@6755231)
wifi0: Could not find STA 00:11:22:33:44:11 for this TX error (@6816632)
wifi0: Could not find STA 00:11:22:33:44:11 for this TX error (@6885910)
wifi0: Could not find STA 00:11:22:33:44:11 for this TX error (@6914376)
wifi0: Could not find STA 00:11:22:33:44:11 for this TX error (@6952377)
wifi0: Could not find STA 00:11:22:33:44:11 for this TX error (@6963145)

--------------------

ping statistics -f
709 packets transmitted, 706 received, 0% packet loss, time 6165ms
rtt min/avg/max/mdev = 2.951/9.247/33.732/4.776 ms, pipe 3, ipg/ewma 
8.708/9.092
 ----------------

Linux 2.4.21-291-default #1 Tue May 24 11:43:42 UTC 2005

------------------

./hostap_diag wlan0
Host AP driver diagnostics information for 'wlan0'

NICID: id=0x8013 v1.0.0 (PRISM II (2.5) Mini-PCI (SST parallel flash))
PRIID: id=0x0015 v1.1.1
STAID: id=0x001f v1.7.4 (station firmware)
------------------------

> hostapd.conf
only this

ssid=MyAP
macaddr_acl=1
accept_mac_file=/you/know
auth_algs=2

> hostapd.accept
00:11:22:33:44:11   (<--- enabled/disabled, it makes no diference)

--------------------------

width 0.2.6 have no this problem

-------------------------

in bridge wlan0, wlan0wds0, wlan0wds1

------------------------

wlan0     IEEE 802.11b  ESSID:"MyAP"  Nickname:"wap3"
          Mode:Master  Frequency:2.422GHz  Access Point: 00:11:22:33:44:13
          Bit Rate:11Mb/s   Sensitivity=1/3
          Retry min limit:8   RTS thr:off   Fragment thr:off
          Encryption key:3333-3333-33   Security mode:restricted
          Power Management:off
          Link Quality:0  Signal level:0  Noise level:0
          Rx invalid nwid:0  Rx invalid crypt:17  Rx invalid frag:0
          Tx excessive retries:81  Invalid misc:182742   Missed beacon:0

wlan0wds  IEEE 802.11b  Nickname:"wap3"
          Mode:Repeater  Frequency:2.422GHz  Access Point: 00:11:22:33:44:11
          Bit Rate:11Mb/s   Sensitivity=1/3
          Retry min limit:8   RTS thr:off   Fragment thr:off
          Encryption key:3333-3333-33   Security mode:restricted
          Power Management:off

wlan0wds  IEEE 802.11b  Nickname:"wap3"
          Mode:Repeater  Frequency:2.422GHz  Access Point: 00:11:22:33:44:12
          Bit Rate:11Mb/s   Sensitivity=1/3
          Retry min limit:8   RTS thr:off   Fragment thr:off
          Encryption key:3333-3333-33   Security mode:restricted
          Power Management:off
-------------------------

and as Tony say, low bitrate !
 -----------------

syslog nothin special ...

-------

only difference is that ap-1 is

Linux 2.4.21-280-default #1 Thu Mar 17 15:55:41 UTC 2005  <--- that can not 
be problem ?

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.shmoo.com/pipermail/hostap/attachments/20050722/e88098ce/attachment.htm