kernel: prism2_hostapd: unknown cmd=12

Kwabbernoot kwabbernoot
Mon May 17 05:29:32 PDT 2004


Hi Kevin,

Thank you, I will try the latest release. Maybe I messed up some 
versions anyway.

Regards,
Arnaud

Kevin Tang wrote:
> Hi Arnaud,
> 
> I encountered the same message "Operation not supported" when I installed
> the lastest development version of hostapd but not the latest
> hostap-driver.  After I installed the latest driver, the message went
> away.  This might not be your problem, but it's an easy fix if it is.
> 
> Kevin
> 
> 
> 
> 
> On Sat, 15 May 2004, Kwabbernoot wrote:
> 
> 
>>Hi all,
>>
>>When I use my RH9 stop script for stopping hostapd is sends this 
>>"prism2_hostapd: unknown cmd=12" to syslog. If I send a TERM by hand 
>>  I get the same.
>>
>>Hostapd is working fine though, I'm just curious. Does somebody know 
>>what command exactly is not understood?
>>
>>hostapd -dd output with a sig TERM:
>>
>>Signal 15 received - terminating
>>Flushing old station entries
>>Deauthenticate all stations
>>ioctl[PRISM2_IOCTL_PRISM2_PARAM]: Operation not supported
>>ioctl[PRISM2_IOCTL_PRISM2_PARAM]: Operation not supported
>>Could not disable PrivacyInvoked for interface wlan0
>>ioctl[PRISM2_IOCTL_HOSTAPD]: Operation not supported
>>Could not remove generic information element from interface wlan0
>>
>>Regards,
>>Arnaud
>>_______________________________________________
>>HostAP mailing list
>>HostAP at shmoo.com
>>http://lists.shmoo.com/mailman/listinfo/hostap
>>
> 
> 
> _______________________________________________
> HostAP mailing list
> HostAP at shmoo.com
> http://lists.shmoo.com/mailman/listinfo/hostap
> 
> 




More information about the Hostap mailing list