Hostap AP to Hostap Managed 44:44:44:44:44:44

[Kelly Hogan]

Hello, 

This must be a simple issue, but I am running hostap 0.1.3 on two
machines, one it AP mode, then one in Managed mode.  Using engenius
2511MP Plus cards in pci mode.  

The ap mode on the unit works well, but the client never seems to join
the essid, just flipping channels like a hyperactive couch potato and
staying at AP 44:44:44:44:44:44   Also noted that the bit rate goes to 2
Mbps and that the interface is dropping packets.

I have tried to iwconfig the ap mac with no joy.  I did see some earlier
emails about this as a problem, hostap to hostap, but no solutions. 

Any suggestions would be appreciated.

firmware 1.7.4/1.1.0

kernel 2.4.20-8

wlan0     IEEE 802.11b  ESSID:"wisp"
          Mode:Managed  Frequency:2.467GHz  Access Point:
44:44:44:44:44:44
          Bit Rate:2Mb/s   Sensitivity=1/3
          Retry min limit:8   RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Management:off
          Link Quality:0/92  Signal level:-69 dBm  Noise level:-90 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:45   Missed beacon:0


wlan0     Link encap:Ethernet  HWaddr 00:02:6F:09:9F:DE
          inet addr:10.0.1.3  Bcast:10.0.1.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:26 overruns:0 frame:0
          TX packets:41 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100
          RX bytes:0 (0.0 b)  TX bytes:2952 (2.8 Kb)
          Interrupt:11 Memory:f1cca000-f1ccb000

 
Thanks,
KH