hostap

PENHOAT Joël FTRD/DMR/ISS joel.penhoat
Fri Jun 11 10:35:30 PDT 2004


Hi,
I try to install hostap v.0.1.1 with linux 2.4.21 + pcmcia-cs 3.2.6

I see this message (Prism2_hw_init failed)

Can any one know why ?


Linux PCMCIA Card Services 3.2.6
  kernel build: 2.4.21 #3 SMP ven jun 11 17:35:12 CEST 2004
  options:  [pci] [apm]
Intel ISA/PCI/CardBus PCIC probe:
PCI: No IRQ known for interrupt pin A of device 01:01.0. Probably buggy MP table.
  TI 1410 rev 01 PCI-to-CardBus at slot 01:01, mem 0x1f801000
    host opts [0]: [isa irq] [pci irq 11] [lat 168/176] [bus 2/5]
    ISA irqs (scanned) = none!<6>    PCI card interrupts, PCI status changes
cs: memory probe 0xa0000000-0xa0ffffff: clean.
hostap_crypt: registered algorithm 'NULL'
hostap_cs: 0.1.1 - 2003-10-19 (Jouni Malinen <jkmaline at cc.hut.fi>)
hostap_cs: setting Vcc=33 (constant)
hostap_cs: CS_EVENT_CARD_INSERTION
hostap_cs: setting Vcc=50 (from config)
Checking CFTABLE_ENTRY 0x01 (default 0x01)
IO window settings: cfg->io.nwin=1 dflt.io.nwin=1
io->flags = 0x0046, io.base=0x0000, len=64
cs: IO port probe 0x0100-0x037f: clean.
cs: IO port probe 0x0400-0x04ff: excluding 0x400-0x43f 0x4d0-0x4d7
cs: IO port probe 0x0a00-0x0aff: excluding 0xa00-0xa7f
cs: IO port probe 0x0c00-0x0cff: excluding 0xc00-0xc1f
hostap_cs: index 0x01: Vcc 5.0, irq 11, io 0x0100-0x013f
hostap_cs: Registered netdevice wlan0
prism2_hw_init: initialized in 40 ms
wlan0: hfa384x_cmd: entry still in list? (entry=d64ec500, type=0, res=0)
wlan0: hfa384x_cmd: command was not completed (res=0, entry=d64ec500, type=0, cmd=0x0021, param0=0xfd0b, EVSTAT=8010 INTEN=0010)
wlan0: interrupt delivery does not seem to work
wlan0: hfa384x_get_rid: CMDCODE_ACCESS failed (res=-110, rid=fd0b, len=8)
Could not get RID for component NIC
hostap_cs: Initialization failed
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.shmoo.com/pipermail/hostap/attachments/20040611/500278a4/attachment.htm 



More information about the Hostap mailing list