D-Link 650P - getting closer

[Martin Whitlock]

Hi,

I have tried to get a new SENAO card with SSF working by following these 
steps:

Jouni Malinen wrote:

>Currently, following steps are needed to initialize D-Link DWL-650 Rev.
>P1:
>
>- make sure that hostap_cs.conf gets updated (new card info needed)
>- compile the driver with downloading support (volatile mode should be
>  enough)
>- acquire suitable firmware images (these have to be compatible with the
>  used wlan card)
>- compile new version of prism2_srec
>
It is a PCMCIA card with NIC 801d. It seems like I can initiate the PRI 
f/w, but the STA f/w does not upload due to incompability. When 
downloading the PRI f/w I get some ignored compatabilities causing 
default settings (see log), I don't know what this means but I suspect 
that it might have something to do with it. Both f/w files should be 
valid for my hardware. Any ideas?

/Martin

[pxadmin at px30_0101 /root]$./prism2_srec -gs wlan0 PM010102.HEX
srec summary for PM010102.HEX
Component: 0x0015 1.1.2 (primary firmware)


Verifying update compatibility and combining data:
Plugging PDR 0400 (NIC configuration): ram16=1 pci=0 (03 00)
OK.

Downloading to volatile memory (RAM).
wifi0: NIC: id=0x8000 v0.0.1
wifi0: PRI: id=0x15 v1.1.2
OK.
[pxadmin at px30_0101 /root]$./prism2_srec -gip wlan0 PM010102.HEX
srec summary for PM010102.HEX
Component: 0x0015 1.1.2 (primary firmware)

ioctl[PRISM2_IOCTL_HOSTAPD]: No data available
STAID not available (maybe running PRI-only)
ioctl[PRISM2_IOCTL_HOSTAPD]: No data available
ioctl[PRISM2_IOCTL_HOSTAPD]: No data available

Verifying update compatibility and combining data:
Incompatible interfaces:
  SREC: role=Actor    variant=2 range=1-1 iface=Controller-Firmware (2)
  card: role=Supplier variant=0 range=1-1 iface=Controller-Firmware (2)
Ignoring incompatibility
Plug record length mismatch (PDR=0x0001): 6 != 16
==> use default
OK.

Downloading to volatile memory (RAM).
wifi0: NIC: id=0x801d v1.0.0
wifi0: PRI: id=0x15 v1.1.2
OK.
[pxadmin at px30_0101 /root]$./prism2_srec -rp wlan0 RF010802.HEX
srec summary for RF010802.HEX
Component: 0x001f 1.8.2 (station firmware)

ioctl[PRISM2_IOCTL_HOSTAPD]: No data available
STAID not available (maybe running PRI-only)
ioctl[PRISM2_IOCTL_HOSTAPD]: No data available
ioctl[PRISM2_IOCTL_HOSTAPD]: No data available

Verifying update compatibility and combining data:
Could not find data position for plugging PDR 0x0413 at 0x0000118a (len=2)
Incompatible update data.
[pxadmin at px30_0101 /root]$