Sat Dec 11 08:03:24 PST 2004
I have a Senao 2511 CD PLUS EXT2 with a 5 dBi Omni RP-TNC antenna running in
Master mode. iwconfig shown below.
I still don't seem to get good range. It seems the same as any other card
How do I check if the card is really transmitting at 200mW ?
If it isn't, then how do I set the txpower?
iwconfig won't set it with iwconfig wlan0 txpower 200mW:
Error for wireless request "Set Tx Power" (8B26) :
SET failed on device wlan0 ; Operation not supported.
gct3102:/etc/rc2.d# iwconfig wlan0
wlan0 IEEE 802.11b ESSID:"gcwl" Nickname:"gct3102"
Mode:Master Frequency:2.422 GHz Access Point: 00:02:6F:09:B1:41
Bit Rate:11 Mb/s Sensitivity=1/3
Retry min limit:8 RTS thr:off Fragment thr:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:635 Invalid misc:3525 Missed beacon:0
Thanks in advance,
More information about the Hostap