WDS and ftp problem
Aditya S C
adityasc
Wed Jun 18 21:14:30 PDT 2003
Hi All
I need a input in regards with using more than one PCMCIA card.
My setup is as follows:
Wireless Card configuration:
PRISM 2/2.5 based,
Secondary firmware Card1-1.4.9 and Card2-1.7.4
16 bit PCMCIA interfaces
Hostap driver version: 0.0.3 (CVS)
Test Setup:
AP1 - Interfaces ---> WLAN11 -- WLAN12 -- ETH10
AP2 - Interfaces ---> WLAN21 -- WLAN22 -- ETH20
WLAN11/ WLAN21 -- Channel 1, ESSID TEST1
WLAN12/ WLAN22 -- Channel 11, ESSID TEST2
WDS links are created in the following manner
WLAN11 <---> WLAN21
WLAN12 <---> WLAN22
I have stations connected to each of the AP's using
cross cable.
AP1 --> ETH10 --> STA1
AP2 --> ETH20 --> STA2
Bridge exists on both the AP.
BR10 --> wlan0wds0 + wlan1wds0 + eth0
BR20 --> wlan0wds0 + wlan1wds0 + eth0
Where,
wlan0wds0 --> WLAN11 <---> WLAN21
wlan1wds0 --> WLAN12 <---> WLAN22
I initiate a ftp between the two stations - STA1 and STA2.
Problem:
One of the AP hangs immediately after issuing a ftp get/ put
command.
Can someone help me out with this:
a) Is the test setup fine?
b) What could be the reason for this failure?
Could some please guide me through this problem???
Thank in advance!
Regards
Aditya
More information about the Hostap
mailing list