channel / mode changing on arm

[Florian Boor]

Hello!

Jouni Malinen wrote:

> Please include 'dmesg' output after such a failure when reporting
> problems.

This happens when you switch to monitor mode and start to change channels.
The card that was uses is a Netgear MA401RA.

Here it is the output from dmesg:

Enabling monitor mode
wlan0: CMD=0x0121 => res=0x7f, resp0=0x0004
wlan0: hfa384x_set_rid: CMDCODE_ACCESS_WRITE failed (res=127, rid=fc28, len=2)
WEP flags setting failed
device wlan0 entered promiscuous mode
wlan0: hfa384x_setup_bap - timeout after
wlan0: hfa384x_set_rid (rid=fc03, len=2) - failed - res=-110
wlan0: hfa384x_setup_bap - timeout before
wlan0: hfa384x_set_rid (rid=fc03, len=2) - failed - res=-110
wlan0: hfa384x_setup_bap - timeout before
wlan0: hfa384x_set_rid (rid=fc03, len=2) - failed - res=-110
wlan0: hfa384x_setup_bap - timeout before
... repeats while changing channel ...

Greetings

Florian

-- 
The dream of yesterday                  Florian Boor
is the hope of today                    Tel: 0271-7411487 | Fax: 0180-5052 5393 9324
and the reality of tomorrow.            florian.boor at bsystems.de | boor at unix-ag.org
[Robert Hutchings Goddard, 1904]        6C 44 30 4C 43 20 6B 61 16 07 0F AA E6 97 70 A8