how to make my AP work?
???
zhengjr
Sun Aug 17 09:36:44 PDT 2003
hello,i got some problem.
i have made a linux kernel supported with devfs.
and i load T1085800.hfw firmware ok!
so now.Other PC's wireless card can connect to my wireless card regarded
as AP.
But
They can't use my AP connect to LAN or Internet.
plz help me.
can anyone teach me how to make it as real AP working?
thx ur reply.
ps:my wire adpater is use DHCP to connect Internet. Is it a problem?
show my ifconfig:
Code:
eth0 Link encap:Ethernet HWaddr 00:D0:59:0F:4F:1D
inet addr:192.168.100.4 Bcast:192.168.100.255 Mask:255.255.255.0
inet6 addr: fe80::2d0:59ff:fe0f:4f1d/10 Scope:Link
inet6 addr: 3ffe:3600:1a:1:2d0:59ff:fe0f:4f1d/64 Scope:Global
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:34312 errors:0 dropped:0 overruns:0 frame:0
TX packets:433 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:21948616 (20.9 Mb) TX bytes:80039 (78.1 Kb)
Interrupt:9 Base address:0x4000
eth1 Link encap:Ethernet HWaddr 00:02:2D:88:19:C1
inet addr:140.116.246.198 Bcast:140.116.246.255
Mask:255.255.255.0
inet6 addr: fe80::202:2dff:fe88:19c1/10 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2779 errors:0 dropped:0 overruns:0 frame:0
TX packets:181 errors:3 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:1864533 (1.7 Mb) TX bytes:27548 (26.9 Kb)
Interrupt:3 Base address:0x100
show my iwconfig:
Code:
eth1 IEEE 802.11-DS ESSID:"simata" Nickname:"localhost.localdomain"
Mode:Master Frequency:2.412GHz Access Point: 00:00:00:00:00:00
Bit Rate=5.5Mb/s Tx-Power=15 dBm Sensitivity:1/3
Retry limit:4 RTS thr:off Fragment thr:off
Encryption key:off
Link Quality:0/0 Signal level:-34 dBm Noise level:-40 dBm
Rx invalid nwid:0 Rx invalid crypt:18 Rx invalid frag:2
Tx excessive retries:28 Invalid misc:0 Missed beacon:0
More information about the Hostap
mailing list