hostap and maccmd

[tuxo at c0re.hysteria.sk]

Hi i have software ap celeron 1000mhz, chipset via and 2x zcom xl626 card, os red hat 7.3. I use hostap 0.0.1, wlan0 is in master mode and i have mac authorization on this card iwpriv wlan0 maccmd 1, in ACL list there is about 40 mac addres.Problem is if ap runs about some hours then some clients card which are connecting on wlan0 are disconnected and they havent signal, then i must reset card or ap....then it will run ok some hours and then will error again ;[

thanx