(no subject)

[Senthil Cumar Palaniappun]

I have no clue about these. Should I return it or exchange it for the older 
supported dwl 650? Becos, someone on some forum said that even after making 
it work the performance was bad on dwl 650. Not sure whether it was his 
setup or whether the card has a bad perf in general. Any thoughts about that 
please?

Thanks,
Senthil


>From: Mark Glines <mark at glines.org>
>Reply-To: Mark Glines <mark at glines.org>
>To: Senthil Cumar Palaniappun <senthilcumar at hotmail.com>
>CC: hostap at shmoo.com
>Subject: Re: (no subject)
>Date: Thu, 14 Nov 2002 09:29:33 -0800
>
>On Thu, Nov 14, 2002 at 12:19:28PM -0500, Senthil Cumar Palaniappun wrote:
> > Hi guys,
> >
> > Thanks a lot for the fast response.
> >
> > Mark -
> >
> > lspci -vv output is as follows (I don't understand most of it)
> >
> > 02:00.0 Network controller: Linksys: Unknown device 8201 (rev 11)
> >        Subsystem: D-Link System Inc: Unknown device 3502
> >        Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- 
>ParErr-
> > Stepping- SERR- FastB2B-
> >        Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
> > <TAbort- <MAbort- >SERR- <PERR-
> >        Interrupt: pin A routed to IRQ 11
> >        Region 0: I/O ports at 4000 [size=256]
> >        Region 1: Memory at 1f800000 (32-bit, non-prefetchable) [size=1K]
> >        Expansion ROM at 1f400000 [size=128K]
> >        Capabilities: [c0] Power Management version 2
> >                Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=100mA
> > PME(D0+,D1+,D2+,D3hot+,D3cold+)
> >                Status: D0 PME-Enable- DSel=0 DScale=0 PME-
>
>I still don't think this is a prism device.  The cards I'm used to have
>4k of RAM, only.  This has 1k of RAM, 256 I/O ports and 128k of ROM??!
>
>Mark

_________________________________________________________________
MSN 8 with e-mail virus protection service: 2 months FREE* 
http://join.msn.com/?page=features/virus