[PATCH v3 1/4] net: gianfar: disable link information

[Renaud Barbier]

Link information are provided by the PHY layer so turn the information
messages into debug messages.

Signed-off-by: Renaud Barbier <renaud.barbier at ametek.com>
---
 drivers/net/gianfar.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/net/gianfar.c b/drivers/net/gianfar.c
index 18b3c8849c..d0f606279f 100644
--- a/drivers/net/gianfar.c
+++ b/drivers/net/gianfar.c
@@ -121,11 +121,11 @@ static void gfar_adjust_link(struct eth_device *edev)
 		out_be32(regs + GFAR_ECNTRL_OFFSET, ecntrl);
 		out_be32(regs + GFAR_MACCFG2_OFFSET, maccfg2);
 
-		dev_info(&edev->dev, "Speed: %d, %s duplex\n", priv->speed,
-		       (priv->duplexity) ? "full" : "half");
+		dev_dbg(&edev->dev, "Speed: %d, %s duplex\n", priv->speed,
+				(priv->duplexity) ? "full" : "half");
 
 	} else {
-		dev_info(&edev->dev, "No link.\n");
+		dev_dbg(&edev->dev, "No link.\n");
 	}
 }
 
-- 
2.43.0