[PATCH 6/6] arm: imx8mp: add karo electronics qsxp imx8mp som support

[Ahmad Fatoum]

Hello Stefan,

On 11.03.24 14:32, Stefan Kerkmann wrote:
> Hello Ahmad,
> 
> On 11.03.24 11:13, Ahmad Fatoum wrote:
>> Hello Stefan,
>>
>> On 11.03.24 10:10, Stefan Kerkmann wrote:
>>> From: Marc Kleine-Budde <mkl at pengutronix.de>
>>>
>>> The Ka-Ro QSXP is a i.MX8M Plus solder down system on module. This
>>> commit adds support for the SOM on the QSBASE4 RDK.
>>>
>>> [1]: https://www.karo-electronics.de/qsxp
>>>
>>> Signed-off-by: Marc Kleine-Budde <mkl at pengutronix.de>
>>> Signed-off-by: Stefan Kerkmann <s.kerkmann at pengutronix.de>
>>> ---
>>>  arch/arm/boards/Makefile                           |    1 +
>>>  arch/arm/boards/karo-qsxp-ml81/Makefile            |    4 +
>>>  arch/arm/boards/karo-qsxp-ml81/board.c             |   35 +
>>>  .../flash-header-karo-qsxp-ml81.imxcfg             |    9 +
>>>  arch/arm/boards/karo-qsxp-ml81/lowlevel.c          |  102 ++
>>>  arch/arm/boards/karo-qsxp-ml81/lowlevel.h          |    8 +
>>>  arch/arm/boards/karo-qsxp-ml81/lpddr4-timing.c     | 1597 ++++++++++++++++++++
>>
>> If QSXP is the SoM name, rename the folder name to drop ml81.
>>
> 
> See reply to patch 5/6, the full manufacturer part number is `QSXP-ML81`
> therefore I vote to keep the `ml81` part.

Ok, can you call it QSXP-ML81 in the commit message?

>> JFYI, if you want to dynamic frequency scaling for DDR, you'll need some
>> more entries here.
>>
> 
> I'm unfamiliar with dynamic frequency scaling, so I'm not sure if we
> need/want more for a first support of this SOM?

No, you don't need more. This is Just For Your Information. Dynamic Frequency
Scaling can be useful to reduce power usage.


Cheers,
Ahmad


-- 
Pengutronix e.K.                           |                             |
Steuerwalder Str. 21                       | http://www.pengutronix.de/  |
31137 Hildesheim, Germany                  | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |