[PATCH v2] net: phy: print error messages to log

[Johannes Zink]

Previously the phy core did just print info and error messages to
console, but they did not show up in the system log.

Now the dev_info and dev_err macros are used instead of raw puts,
they are now nicely formatted and show up in the log.

Signed-off-by: Johannes Zink <j.zink at pengutronix.de>
---
Changelog:

v1 -> v2: Worked in Ahmad's review findings:
          - use dev_err and dev_info instead of pr_err and pr_info

          Thank you for your review!

 drivers/net/phy/phy.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/net/phy/phy.c b/drivers/net/phy/phy.c
index 54dbbca7255a..dbc30b66b828 100644
--- a/drivers/net/phy/phy.c
+++ b/drivers/net/phy/phy.c
@@ -462,7 +462,7 @@ int phy_device_connect(struct eth_device *edev, struct mii_bus *bus, int addr,
 	ret = -ENODEV;
 out:
 	if (ret)
-		puts("Unable to find a PHY (unknown ID?)\n");
+		dev_err(&edev->dev, "Unable to find a PHY (unknown ID?)\n");
 
 	return ret;
 }
@@ -675,7 +675,7 @@ int genphy_aneg_done(struct phy_device *phydev)
 
 	/* Restart auto-negotiation if remote fault */
 	if (bmsr & BMSR_RFAULT) {
-		puts("PHY remote fault detected\n"
+		dev_info(&phydev->dev, "PHY remote fault detected\n"
 		     "PHY restarting auto-negotiation\n");
 		phy_write(phydev, MII_BMCR,
 				  BMCR_ANENABLE | BMCR_ANRESTART);
-- 
2.39.2