[PATCH 1/4] ARM: boards: polyhex-debix: fix RGMII pin setup

[Marco Felsch]

On the Debix SBC the EQOS interface is used as primary interface, the
FEC pins are routed to the extension header. On the other hand the Debix
SoM/Baseboard combination both interfaces are used. So fix the RGMII pin
setup by adding the EQOS pin as well and keep the FEC.

Signed-off-by: Marco Felsch <m.felsch at pengutronix.de>
---
 arch/arm/boards/polyhex-debix/board.c | 3 ++-
 include/mach/imx/iomux-mx8mp.h        | 1 +
 2 files changed, 3 insertions(+), 1 deletion(-)

diff --git a/arch/arm/boards/polyhex-debix/board.c b/arch/arm/boards/polyhex-debix/board.c
index d668dd1816f8..46cb18c5889c 100644
--- a/arch/arm/boards/polyhex-debix/board.c
+++ b/arch/arm/boards/polyhex-debix/board.c
@@ -28,7 +28,8 @@ static int polyhex_debix_probe(struct device *dev)
 
 	/* Enable RGMII TX clk output */
 	val = readl(MX8MP_IOMUXC_GPR_BASE_ADDR + MX8MP_IOMUXC_GPR1);
-	val |= MX8MP_IOMUXC_GPR1_ENET1_RGMII_EN;
+	val |= MX8MP_IOMUXC_GPR1_ENET1_RGMII_EN |
+	       MX8MP_IOMUXC_GPR1_ENET_QOS_RGMII_EN;
 	writel(val, MX8MP_IOMUXC_GPR_BASE_ADDR + MX8MP_IOMUXC_GPR1);
 
 	return 0;
diff --git a/include/mach/imx/iomux-mx8mp.h b/include/mach/imx/iomux-mx8mp.h
index b410eaebc8ac..98e340d3dad1 100644
--- a/include/mach/imx/iomux-mx8mp.h
+++ b/include/mach/imx/iomux-mx8mp.h
@@ -1099,5 +1099,6 @@ static inline void imx8mp_setup_pad(iomux_v3_cfg_t pad)
 
 #define MX8MP_IOMUXC_GPR1			0x4
 #define MX8MP_IOMUXC_GPR1_ENET1_RGMII_EN	BIT(22)
+#define MX8MP_IOMUXC_GPR1_ENET_QOS_RGMII_EN	BIT(21)
 
 #endif  /* __ASM_ARCH_IMX8MP_PINS_H__ */
-- 
2.39.2