[PATCH 00/11] ARM: at91: sama5d4: add basic Wifx L1 support

[Sam Ravnborg]

Hi Ahmad,

On Wed, Dec 14, 2022 at 11:58:20AM +0100, Ahmad Fatoum wrote:
> The Wifx L1 is a SAMA5D4 LoRaWAN gateway. It boots from NAND, but this
> can be overridden by inserting a bootable SD-Card.
> 
> This first port only provides second-stage SD-Card support.
Nice.

I browsed the individual patches - they all looked good.

The DT file in patch 11 looks like a file that would be a good linux
kernel candidate - but I guess this is for someone else to do.

Full series are:
Acked-by: Sam Ravnborg <sam at ravnborg.org>

I look forward to the day where the remaining three sama5d boards are all
multi-board and DT-enabled. This patch-set brings us a step closer.


Do you know if there is a way to read bootsource from an at91sam92XX
CPU / ROMBOOT code? There as nothing mentioned in the datasheet I looked at.

As I have fired up my at91sam9263 board for the Xmas holidays I may
try to play around with it a bit, but for now I have only SD-card boot working.

	Sam


It enables
> use of UART, I2C/EEPROM, Ethernet and SD-Card. For NAND use on SAMA5D4,
> an updated Linux driver was ported to barebox.
> This will follow separately.
> 
> Ahmad Fatoum (11):
>   ARM: at91: sama5: switch to nonnaked entry functions
>   ARM: at91: sama5d4: add entry point helpers
>   ARM: at91: sama5d4: enable for DT use
>   net: macb: match atmel,sama5d4-gem compatible
>   i2c: at91: extend for SAMA5D4 support
>   eeprom: at24: add 24mac402/602 support
>   driver: always ensure probe of RAM registered with mem_platform_driver
>   common: deep-probe: don't build without CONFIG_OFDEVICE
>   pinctrl: at91: make deep-probe compatible
>   ARM: at91: make bootsource code generic to all SAMA5
>   ARM: at91: SAMA5D4: add Wifx L1 support
> 
>  arch/arm/boards/Makefile                      |   1 +
>  .../boards/microchip-ksz9477-evb/lowlevel.c   |   6 +-
>  .../arm/boards/sama5d27-giantboard/lowlevel.c |   4 +-
>  arch/arm/boards/sama5d27-som1/lowlevel.c      |   4 +-
>  arch/arm/boards/sama5d3_xplained/lowlevel.c   |   6 +-
>  arch/arm/boards/sama5d4_wifx/Makefile         |   4 +
>  arch/arm/boards/sama5d4_wifx/board.c          |  38 ++
>  arch/arm/boards/sama5d4_wifx/lowlevel.c       |  18 +
>  arch/arm/dts/Makefile                         |   1 +
>  arch/arm/dts/at91-sama5d4_wifx_l1.dts         | 358 ++++++++++++++++++
>  arch/arm/dts/sama5d4.dtsi                     |   9 +
>  arch/arm/mach-at91/Kconfig                    |  11 +
>  arch/arm/mach-at91/Makefile                   |   3 +-
>  arch/arm/mach-at91/bootm-barebox.c            |   3 +-
>  arch/arm/mach-at91/ddramc.c                   |   7 +
>  arch/arm/mach-at91/include/mach/barebox-arm.h |  22 +-
>  arch/arm/mach-at91/include/mach/cpu.h         |   1 -
>  arch/arm/mach-at91/include/mach/ddramc.h      |   1 +
>  .../mach-at91/include/mach/sama5_bootsource.h |   5 +
>  arch/arm/mach-at91/sama5_bootsource.c         |  36 ++
>  arch/arm/mach-at91/sama5d2.c                  |  15 -
>  arch/arm/mach-at91/setup.c                    |   3 -
>  common/Makefile                               |   2 +-
>  drivers/eeprom/at24.c                         |   2 +
>  drivers/i2c/busses/i2c-at91.c                 |  14 +-
>  drivers/net/macb.c                            |   1 +
>  drivers/pinctrl/pinctrl-at91.c                |  20 +-
>  images/Makefile.at91                          |   4 +
>  include/deep-probe.h                          |   7 +
>  include/driver.h                              |  13 +-
>  30 files changed, 571 insertions(+), 48 deletions(-)
>  create mode 100644 arch/arm/boards/sama5d4_wifx/Makefile
>  create mode 100644 arch/arm/boards/sama5d4_wifx/board.c
>  create mode 100644 arch/arm/boards/sama5d4_wifx/lowlevel.c
>  create mode 100644 arch/arm/dts/at91-sama5d4_wifx_l1.dts
>  create mode 100644 arch/arm/dts/sama5d4.dtsi
>  create mode 100644 arch/arm/mach-at91/sama5_bootsource.c
> 
> -- 
> 2.30.2
>