Compiled in boot environment and dtbo files

[Konstantin Kletschke]

I got the uart1 and uart4 available on boot after I changed the appropiate dtsi in this way:

--- arch/arm/boot/dts/am335x-bone-common.dtsi_ORIG	2021-01-29 15:08:15.085080693 +0100
+++ arch/arm/boot/dts/am335x-bone-common.dtsi	2021-06-22 11:26:48.197115876 +0200
@@ -96,6 +96,20 @@
 		>;
 	};
 
+	uart1_pins: pinmux_uart1_pins {
+		pinctrl-single,pins = <
+			AM33XX_PADCONF(AM335X_PIN_UART1_RXD, PIN_INPUT_PULLUP, MUX_MODE0)
+			AM33XX_PADCONF(AM335X_PIN_UART1_TXD, PIN_OUTPUT_PULLDOWN, MUX_MODE0)
+		>;
+	};
+
+	uart4_pins: pinmux_uart4_pins {
+		pinctrl-single,pins = <
+            AM33XX_PADCONF(AM335X_PIN_GPMC_WAIT0, PIN_INPUT_PULLUP, MUX_MODE6)	/* (T17) gpmc_wait0.uart4_rxd */
+            AM33XX_PADCONF(AM335X_PIN_GPMC_WPN, PIN_OUTPUT_PULLDOWN, MUX_MODE6)	/* (U17) gpmc_wpn.uart4_txd */
+		>;
+	};
+
 	clkout2_pin: pinmux_clkout2_pin {
 		pinctrl-single,pins = <
 			AM33XX_PADCONF(AM335X_PIN_XDMA_EVENT_INTR1, PIN_OUTPUT_PULLDOWN, MUX_MODE3)	/* xdma_event_intr1.clkout2 */
@@ -190,6 +204,20 @@
 
 	status = "okay";
 };
+
+&uart1 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&uart1_pins>;
+
+	status = "okay";
+};
+
+&uart4 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&uart4_pins>;
+
+	status = "okay";
+};
 
 &usb {
 	status = "okay”;


This change is activating and enabling those uarts at boot and does pin muxing properly.
It’s not muxing only as I previously assumed wrongly investigating the initial overlays.

I will go with that and if in future it is required programming proper overlays for
this that will be a side quest unrelated to barebox.

I just put a result into this mail thread if someone stumbles upon this.

Kind Regards
Konsti


-------------- next part --------------
A non-text attachment was scrubbed...
Name: smime.p7s
Type: application/pkcs7-signature
Size: 4124 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/barebox/attachments/20210622/a539cc01/attachment.p7s>