[PATCH v1 00/11] prepare Protonic board code for mainline
Oleksij Rempel
o.rempel at pengutronix.de
Thu Jul 23 06:33:15 EDT 2020
This patch series is a preparation and actual Protonic board code.
Following changes was made in the main code:
- register DT root node as device to make it possible to loade board
code as usual driver
- provide helpers to read ethernet mac from nvmem cell register in a
devicetree.
- provide barebox-serial driver which should be a nvmem cell consumer and
serial-number DT property provider.
- provide gpio helper to read gpio based board revision.
Oleksij Rempel (11):
ARM: dts: imx6q-prti6q: fix PHY register
of: base: register DT root as device
ARM: embest-riotboard: port board file to the driver model
net: port nvmem_get_mac_address() from linux kernel
of: of_net: sync of_get_mac_address() with latest kernel version
net: fec_imx: use of_get_mac_address() to get mac address out of DT
of: of_device_get_match_compatible() helper
gpiolib: add gpio_array_to_id helper to get ID out of GPIO array
ARM: protonic-imx6: port protonic specific board code
of: add barebox-serial driver
ARM: dts: imx6q-prti6q: add barebox.serial node
arch/arm/boards/embest-riotboard/board.c | 18 +-
arch/arm/boards/protonic-imx6/Makefile | 1 +
arch/arm/boards/protonic-imx6/board.c | 598 +++++++++++++++++++++++
arch/arm/dts/imx6q-prti6q.dts | 9 +-
drivers/gpio/gpiolib.c | 28 ++
drivers/net/fec_imx.c | 9 +
drivers/of/Makefile | 2 +-
drivers/of/barebox_serial.c | 111 +++++
drivers/of/base.c | 5 +
drivers/of/device.c | 12 +
drivers/of/of_net.c | 63 ++-
include/gpio.h | 5 +
include/net.h | 4 +
include/of_device.h | 6 +
net/eth.c | 38 ++
15 files changed, 889 insertions(+), 20 deletions(-)
create mode 100644 arch/arm/boards/protonic-imx6/board.c
create mode 100644 drivers/of/barebox_serial.c
--
2.27.0
More information about the barebox
mailing list