[PATCH v2 00/13] prepare Protonic board code for mainline

[Sascha Hauer]

On Wed, Aug 05, 2020 at 12:16:15PM +0200, Oleksij Rempel wrote:
> changes v2:
> - add power init support for KvG boards
> - spell fixes
> - do not print error on probe exit
> - add of_console_get_by_alias() helper
> - free requested gpio array
> - exit fec init only in case of PROBE_DEFERED
> 
> This patch series is a preparation and actual Protonic board code.
> Following changes was made in the main code:
> - register DT root node as device to make it possible to loade board
>   code as usual driver
> - provide helpers to read ethernet mac from nvmem cell register in a
>   devicetree.
> - provide barebox-serial driver which should be a nvmem cell consumer
>   and
>   serial-number DT property provider.
> - provide gpio helper to read gpio based board revision.
> 
> Oleksij Rempel (13):
>   ARM: dts: imx6q-prti6q: fix PHY register
>   ARM: dts: imx6: vicut1: fix network support
>   of: base: register DT root as device
>   ARM: embest-riotboard: port board file to the driver model
>   net: port nvmem_get_mac_address() from linux kernel
>   of: of_net: sync of_get_mac_address() with latest kernel version
>   net: fec_imx: use of_get_mac_address() to get mac address out of DT
>   of: of_device_get_match_compatible() helper
>   gpiolib: add gpio_array_to_id helper to get ID out of GPIO array
>   common: console_common: add of_console_get_by_alias() helper
>   ARM: protonic-imx6: port Protonic specific board code
>   of: add barebox-serial driver
>   ARM: dts: imx6q-prti6q: add barebox,serial-number node

Applied 1-4 for now.

Sascha


-- 
Pengutronix e.K.                           |                             |
Steuerwalder Str. 21                       | http://www.pengutronix.de/  |
31137 Hildesheim, Germany                  | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |