[PATCH v1 00/12] ARM: stm32mp: add drivers for GPIO, pinctrl

Sascha Hauer s.hauer at pengutronix.de
Thu Jun 20 07:32:28 PDT 2019


On Mon, Jun 17, 2019 at 05:07:39PM +0200, Ahmad Fatoum wrote:
> Feedback welcome.
> 
> I still have a patch that ports designware_qos from U-Boot to barebox
> sitting on my branch. It works fine, but it needs refactoring, so it
> can reuse existing functionality in the generic designware MAC driver
> that's already in barebox. That will take a while, but if there's interest
> in it, I can push the current state somwhere till then.
> 
> Cheers,
> Ahmad Fatoum (12):
>   ARM: dts: stm32mp157a-dk1.dts: include upstream dts before barebox'
>   ARM: dts: stm32mp: factor out common DK nodes into dtsi
>   gpiolib: add gpio_get_chip helper
>   driver: add stubs for hardware spinlocks
>   pinctrl: add driver for STM32 GPIO and pin multiplexer
>   ARM: dts: stm32mp157a-dk1: enable heartbeat and error LEDs
>   ARM: stm32mp: turn on GPIO related options
>   ARM: stm32mp157c-dk2: add board-specific sysconf fixups
>   ARM: psci: fix erroneous call of ->system_reset on system_off
>   ARM: sm: move get_gicd_base_address to header for reuse
>   ARM: stm32mp: implement PSCI support
>   ARM: stm32mp157c-dk2: boot kernel in nonsecure mode

Applied, thanks

Sascha


-- 
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |



More information about the barebox mailing list