[PATCH 3/9] doc: boards: Amazon Kindle 3: apply more formatting

Roland Hieber rohieb at rohieb.name
Mon Jun 11 15:02:29 PDT 2018

Signed-off-by: Roland Hieber <rohieb at rohieb.name>
 Documentation/boards/imx/amazon-kindle-3.rst | 12 ++++++++----
 1 file changed, 8 insertions(+), 4 deletions(-)

diff --git a/Documentation/boards/imx/amazon-kindle-3.rst b/Documentation/boards/imx/amazon-kindle-3.rst
index 50592f2cb9..dffb7efb2d 100644
--- a/Documentation/boards/imx/amazon-kindle-3.rst
+++ b/Documentation/boards/imx/amazon-kindle-3.rst
@@ -14,7 +14,10 @@ vendor modified u-boot imximage.
 To upload and run a new bootloader the device can be put into USB-downloader
 mode by the SOC microcode when Vol+ is pressed during startup. A new USB
 device "SE Blank RINGO" should appear, barebox may be uploaded using
-$ scripts/imx/imx-usb-loader barebox.imximg
+        $ scripts/imx/imx-usb-loader barebox.imximg
 Note: a USB serial ACM console will be launched by a barebox init script
 when the cursor select key is pressed during startup (e.g. before running
@@ -23,6 +26,7 @@ imx-usb-loader)
 Barebox may be used as drop-in replacement for the shipped bootloader.
 When installing the barebox imximg on the eMMC take care not to overwrite
 the partition table and vendor supplied serial numbers stored on the eMMC.
-e.g. just write the imx-header and the application section:
-memcpy -b -s barebox.imximg -d /dev/disk0.imx_header 1024 0 1024
-memcpy -b -s barebox.imximg -d /dev/disk0.self 4096 0 195584
+e.g. just write the imx-header and the application section::
+        memcpy -b -s barebox.imximg -d /dev/disk0.imx_header 1024 0 1024
+        memcpy -b -s barebox.imximg -d /dev/disk0.self 4096 0 195584

More information about the barebox mailing list