[PATCH] ARM: imx: add support for Udoo Neo full

Sascha Hauer s.hauer at pengutronix.de
Fri Jun 30 02:28:42 PDT 2017


On Fri, Jun 30, 2017 at 11:06:11AM +0200, Uwe Kleine-König wrote:
> Hello Sascha,
> 
> On 06/30/2017 08:35 AM, Sascha Hauer wrote:
> > Adding this information is a good idea. In this case the values come
> > from:
> > 
> > /*
> >  * These values are taken from:
> >  * repository: https://github.com/UDOOboard/uboot-imx
> >  * branch: udoo/2015.04.imx
> >  * file: board/udoo/udoo_neo/udoo_neo_basic.cfg
> >  */
> > 
> > I was about to apply Uwes patch along with this comment, but I just
> > realized that the values are from udoo_neo_basic whereas the patch
> > seems to support the udoo_neo_full. The udoo neo full has slightly
> > different calibration values in the branch above, but probably they
> > work on both boards. Uwe, do you know which hardware we actually have
> > and support?
> 
> The patch I submitted is tested only on a udoo neo full. Does this
> answer your question?

Then we should probably use the register values for the udoo neo full,
not for the udoo neo basic.

Sascha

-- 
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |



More information about the barebox mailing list