[PATCH v2 3/3] ARM: i.MX6: add Technexion Pico Hobbit support
Michael Grzeschik
mgr at pengutronix.de
Tue Jun 6 04:03:48 PDT 2017
On Tue, Jun 06, 2017 at 08:18:40AM +0200, Sascha Hauer wrote:
> On Fri, Jun 02, 2017 at 03:18:08PM +0200, Michael Grzeschik wrote:
> > This adds support support for the i.MX6UL Technexion Pico Hobbit.
> > The board comes with different amounts of RAM. We create one image
> > for the 256MB and one for the 512MB variant.
> >
> > Signed-off-by: Michael Grzeschik <m.grzeschik at pengutronix.de>
> > ---
> > v1 -> v2: - removed already prepared clock setup
> >
> > +
> > +&usdhc1 {
> > + #address-cells = <1>;
> > + #size-cells = <1>;
> > +
> > + partition at 0 {
> > + label = "barebox";
> > + reg = <0x0 0xc0000>;
> > + };
> > +
> > + environment_usdhc1: partition at c0000 {
> > + label = "barebox-environment";
> > + reg = <0xc0000 0x40000>;
> > + };
> > +};
> > +
> > +&fec2 {
> > + /*
> > + There are two possible ways to start the phy. Let the hardware
> > + reset it properly or reset it a second time in software.
> > + Unfortunetly the phy needs some microseconds after reset to
> > + settle down. As there is no property like
> > + phy-post-reset-delay, we better leave the reset to the
> > + hardware.
> > + */
> > + /delete-property/ phy-reset-gpios;
> > + /delete-property/ phy-reset-duration;
>
> Recent Kernels support phy-reset-post-delay. Can we just add support for
> it in barebox aswell?
Could we for now stick with this? When I write the phy-reset-post-delay
patches I will then adopt this node in the regarding series. This gives
me some time, as I can not test the post-delay patch in the next two
weeks.
Thanks,
Michael
--
Pengutronix e.K. | |
Industrial Linux Solutions | http://www.pengutronix.de/ |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 |
Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |
More information about the barebox
mailing list