[PATCH v2 0/23] at91: move reset vector to board code

[Sam Ravnborg]

Hi Lucas.
> 
> Just to let you know the current status here: While I think you are on
> the right track with this, I'm currently lacking the bandwidth to
> properly review this series. I'm a bit hesitant to just throw it into
> -next without any kind of review, so I'm still hoping for others to take
> a look.

Thanks for the heads-up.
Review is a must as I am in unknown land here.
The most important part is if the apporach is correct or not.

I have continued with the effort to DT enable
the at91sam9263ek board and have a barebox that
boots using DT now with most stuff working.

atmel_lcdfb did not support DT which I have added.
All other drivers worked more or less out-of-the-box.

In the process there have been a few cleanups and fixes
and I will post the patches after some more testing.

Not everything is working yet:
- the NAND cannot read BBT (NAND is properly identified)
- environment load /dev/env0 fails (maybe related to the above)
- no kernel booted yet
- bootstrap not tested (will provide a defconfig if I get it working)
- network is not yet tested

I expect to work on the above list and hold back patches
until everything is working. That will take a few days.

If everything goes like for the other challenges I will
run to the other side of the forest to pick up a small
splinter of wood in my effort to find a fix.
Which is OK as this is part of the fun :-)

	Sam