State Framework and dtb

[Çağlar Kilimci]

2017-04-04 9:22 GMT+03:00 Sascha Hauer <s.hauer at pengutronix.de>:
> On Mon, Apr 03, 2017 at 11:59:50PM +0300, Çağlar Kilimci wrote:
>> Hello,
>>
>> Finally, I updated and patched the code and now I can see state at 0
>> device in the of_dump:
>
> Ok, looks good. How does the boot log look like? Still the same?

I think so. Here it is:
barebox 2017.03.0-00129-g444ee36 #1 Mon Apr 3 10:28:04 +03 2017


Board: Phytec phyCORE AM335x
omap-hsmmc 48060000.mmc: registered as 48060000.mmc
booting from MMC
mmc0: detected SD card version 2.0
mmc0: registered mmc0


barebox 2017.03.0-00153-g880fa12-dirty #3 Mon Apr 3 23:14:34 +03 2017


Board: Phytec phyCORE AM335x
cpsw 4a100000.ethernet: detected phy mask 0x3
mdio_bus: miibus0: probed
eth0: got preset MAC address: a0:f6:fd:6c:0d:b0
am335x-phy-driver 47401b00.usb-phy: am_usbphy 87f71cdc enabled
musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, bulk combine, bulk
split, HB-ISO Rx, HB-ISO Tx, SoftConn)
musb-hdrc: MHDRC RTL version 2.0
musb-hdrc: setup fifo_mode 4
musb-hdrc: 28/31 max ep, 16384/16384 memory
m25p80 m25p80 at 00: unrecognized JEDEC id bytes: 00,  0,  0
m25p80 m25p80 at 00: probe failed: No such file or directory
i2c-omap 44e0b000.i2c: bus 0 rev0.11 at 400 kHz
omap-hsmmc 48060000.mmc: registered as 48060000.mmc
mmc0: detected SD card version 2.0
mmc0: registered mmc0
omap_wdt 44e35000.wdt: OMAP Watchdog Timer Rev 0x01
nand: ONFI flash detected
nand: NAND device: Manufacturer ID: 0x2c, Chip ID: 0xf1 (Micron
MT29F1G08ABADAH4), 128MiB, page size: 2048, OOB size: 64
netconsole: registered as netconsole-1
malloc space: 0x87efef60 -> 0x8fdfdebf (size 127 MiB)
running /env/bin/init...
eth0: 100Mbps full duplex link detected
DHCP client bound to address 192.168.1.29

Hit m for menu or any other key to stop autoboot:    3

type exit to get to the menu
barebox at Phytec phyCORE AM335x:/


-- 
Çağlar Kilimci