[PATCH 2/6] net: phy: micrel: use BIT macro

Philipp Zabel p.zabel at pengutronix.de
Tue Feb 2 03:17:31 PST 2016


Based on kernel commit 00aee095000c ("net: phy: micrel: use BIT macro")
by Johan Hovold <johan at kernel.org>.

Signed-off-by: Philipp Zabel <p.zabel at pengutronix.de>
---
 drivers/net/phy/micrel.c | 18 +++++++++---------
 1 file changed, 9 insertions(+), 9 deletions(-)

diff --git a/drivers/net/phy/micrel.c b/drivers/net/phy/micrel.c
index 2f31906..0c97e25 100644
--- a/drivers/net/phy/micrel.c
+++ b/drivers/net/phy/micrel.c
@@ -25,17 +25,17 @@
 
 /* Operation Mode Strap Override */
 #define MII_KSZPHY_OMSO				0x16
-#define KSZPHY_OMSO_B_CAST_OFF			(1 << 9)
-#define KSZPHY_OMSO_RMII_OVERRIDE		(1 << 1)
-#define KSZPHY_OMSO_MII_OVERRIDE		(1 << 0)
+#define KSZPHY_OMSO_B_CAST_OFF			BIT(9)
+#define KSZPHY_OMSO_RMII_OVERRIDE		BIT(1)
+#define KSZPHY_OMSO_MII_OVERRIDE		BIT(0)
 
 /* general PHY control reg in vendor specific block. */
 #define	MII_KSZPHY_CTRL			0x1F
 /* bitmap of PHY register to set interrupt mode */
-#define KSZPHY_CTRL_INT_ACTIVE_HIGH		(1 << 9)
-#define KSZ9021_CTRL_INT_ACTIVE_HIGH		(1 << 14)
-#define KS8737_CTRL_INT_ACTIVE_HIGH		(1 << 14)
-#define KSZ8051_RMII_50MHZ_CLK			(1 << 7)
+#define KSZPHY_CTRL_INT_ACTIVE_HIGH		BIT(9)
+#define KSZ9021_CTRL_INT_ACTIVE_HIGH		BIT(14)
+#define KS8737_CTRL_INT_ACTIVE_HIGH		BIT(14)
+#define KSZ8051_RMII_50MHZ_CLK			BIT(7)
 
 /* Write/read to/from extended registers */
 #define MII_KSZPHY_EXTREG                       0x0b
@@ -231,8 +231,8 @@ static int ksz9031_config_init(struct phy_device *phydev)
 }
 
 #define KSZ8873MLL_GLOBAL_CONTROL_4	0x06
-#define KSZ8873MLL_GLOBAL_CONTROL_4_DUPLEX	(1 << 6)
-#define KSZ8873MLL_GLOBAL_CONTROL_4_SPEED	(1 << 4)
+#define KSZ8873MLL_GLOBAL_CONTROL_4_DUPLEX	BIT(6)
+#define KSZ8873MLL_GLOBAL_CONTROL_4_SPEED	BIT(4)
 static int ksz8873mll_read_status(struct phy_device *phydev)
 {
 	int regval;
-- 
2.7.0.rc3




More information about the barebox mailing list