[PATCH 2/3] net: smc1111: extend the driver for 91c94 and 91c96 support
Robert Jarzmik
robert.jarzmik at free.fr
Mon Jan 26 13:34:09 PST 2015
All the smcs family chips 91c94, 91c96, 91c100, 91c111 share almost the
same behavior and register sets. The noticeable exceptions are coped
with in this patch, ie :
- 91c94 and 91c96 only have an internal 10 Mbps phy
The registers used for phy discovery on later chips will corrupt the
91c96 state.
- 91c94 and 91c96 have a control and config register quite different
from their 91c1xx conterparts
A platform data user defined couple of registers is introduced. If
these values are 0, 91c1xx legacy behavior is assumed.
Signed-off-by: Robert Jarzmik <robert.jarzmik at free.fr>
---
drivers/net/smc91111.c | 40 +++++++++++++++++++++++++++++++++++-----
include/net/smc91111.h | 2 ++
2 files changed, 37 insertions(+), 5 deletions(-)
diff --git a/drivers/net/smc91111.c b/drivers/net/smc91111.c
index 3e66c4d..880bf75 100644
--- a/drivers/net/smc91111.c
+++ b/drivers/net/smc91111.c
@@ -439,6 +439,10 @@ struct smc91c111_priv {
struct smc91111_accessors a;
void __iomem *base;
int qemu_fixup;
+ int version;
+ int revision;
+ unsigned int control_setup;
+ unsigned int config_setup;
};
#if (SMC_DEBUG > 2 )
@@ -854,6 +858,7 @@ static int smc91c111_phy_read(struct mii_bus *bus, int phyaddr, int phyreg)
static void smc91c111_reset(struct eth_device *edev)
{
struct smc91c111_priv *priv = (struct smc91c111_priv *)edev->priv;
+ int rev_vers;
/* This resets the registers mostly to defaults, but doesn't
affect EEPROM. That seems unnecessary */
@@ -869,8 +874,11 @@ static void smc91c111_reset(struct eth_device *edev)
/* Release from possible power-down state */
/* Configuration register is not affected by Soft Reset */
- SMC_outw(priv, SMC_inw(priv, CONFIG_REG) | CONFIG_EPH_POWER_EN,
- CONFIG_REG);
+ if (priv->config_setup)
+ SMC_outw(priv, priv->config_setup, CONFIG_REG);
+ else
+ SMC_outw(priv, SMC_inw(priv, CONFIG_REG) | CONFIG_EPH_POWER_EN,
+ CONFIG_REG);
SMC_SELECT_BANK(priv, 0);
@@ -883,7 +891,10 @@ static void smc91c111_reset(struct eth_device *edev)
/* set the control register */
SMC_SELECT_BANK(priv, 1);
- SMC_outw(priv, CTL_DEFAULT, CTL_REG);
+ if (priv->control_setup)
+ SMC_outw(priv, priv->control_setup, CTL_REG);
+ else
+ SMC_outw(priv, CTL_DEFAULT, CTL_REG);
/* Reset the MMU */
SMC_SELECT_BANK(priv, 2);
@@ -899,6 +910,14 @@ static void smc91c111_reset(struct eth_device *edev)
/* Disable all interrupts */
SMC_outb(priv, 0, IM_REG);
+
+ /* Check chip revision (91c94, 91c96, 91c100, ...) */
+ SMC_SELECT_BANK(priv, 3);
+ rev_vers = SMC_inb(priv, REV_REG);
+ priv->revision = (rev_vers >> 4) & 0xf;
+ priv->version = rev_vers & 0xf;
+ dev_info(edev->parent, "chip is revision=%2d, version=%2d\n",
+ priv->revision, priv->version);
}
static void smc91c111_enable(struct eth_device *edev)
@@ -918,10 +937,16 @@ static int smc91c111_eth_open(struct eth_device *edev)
/* Configure the Receive/Phy Control register */
SMC_SELECT_BANK(priv, 0);
- SMC_outw(priv, RPC_DEFAULT, RPC_REG);
+ if (priv->revision > 4)
+ SMC_outw(priv, RPC_DEFAULT, RPC_REG);
smc91c111_enable(edev);
+ if (priv->revision <= 4) {
+ dev_info(edev->parent, "force link at 10Mpbs on internal phy\n");
+ return 0;
+ }
+
ret = phy_device_connect(edev, &priv->miibus, 0, NULL,
0, PHY_INTERFACE_MODE_NA);
@@ -1332,6 +1357,10 @@ static int smc91c111_probe(struct device_d *dev)
priv->qemu_fixup = pdata->qemu_fixup;
if (pdata->accessors)
priv->a = *pdata->accessors;
+ if (pdata->config_setup)
+ priv->config_setup = pdata->config_setup;
+ if (pdata->control_setup)
+ priv->control_setup = pdata->control_setup;
}
edev->init = smc91c111_init_dev;
@@ -1353,7 +1382,8 @@ static int smc91c111_probe(struct device_d *dev)
smc91c111_reset(edev);
- mdiobus_register(&priv->miibus);
+ if (priv->revision > 4)
+ mdiobus_register(&priv->miibus);
eth_register(edev);
return 0;
diff --git a/include/net/smc91111.h b/include/net/smc91111.h
index d56b1a9..56f08f0 100644
--- a/include/net/smc91111.h
+++ b/include/net/smc91111.h
@@ -22,6 +22,8 @@ struct smc91111_accessors {
struct smc91c111_pdata {
int qemu_fixup;
struct smc91111_accessors *accessors;
+ int config_setup;
+ int control_setup;
};
#endif /* __SMC91111_H__ */
--
2.1.0
More information about the barebox
mailing list