[PATCH] ARM: atmel: sama5d3xek: let emac auto detect phy addr

[Jean-Christophe PLAGNIOL-VILLARD]

> On Jan 23, 2015, at 4:04 PM, Sascha Hauer <s.hauer at pengutronix.de> wrote:
> 
> On Fri, Jan 23, 2015 at 03:53:48PM +0800, Jean-Christophe PLAGNIOL-VILLARD wrote:
>> 
>>> On Jan 23, 2015, at 3:51 PM, Sascha Hauer <s.hauer at pengutronix.de> wrote:
>>> 
>>> On Thu, Jan 22, 2015 at 03:26:53PM +0800, Bo Shen wrote:
>>>> On the SAMA5D35 the EMAC phy addr is 1 while not 0. So, let
>>>> the EMAC auto detect phy addr, or else hard code to 0, the
>>>> ethernet can not work on SAMA5D35 board.
>>>> 
>>>> Signed-off-by: Bo Shen <voice.shen at atmel.com>
>>> 
>>> There ere boards with different phy addresses around, so
>>> the current state does not work on all boards anyway. So the worst
>>> thing that can happen with this and the other patch for the gmac is
>>> that now another set of boards does not work. Let's give it a try.
>>> I'm open to reports when now some board stops working.
>>> 
>>> Applied this and the gmac patch.
>> 
>> except we can auto detect the board we are running from
>> so it will be better to specify it at Run time
>> 
>> as we have issue on auto detect on some of them
> 
> Ok, so your suggestion is to detect the board (type, revision?) and
> set phy_addr correctly based on this information, right? Fine with me
> aswell. Is it known which boards have which phy_addr?

yes and I already write the detection code in barebox

Best Regards,
J.
> 
> Sascha
> 
> -- 
> Pengutronix e.K.                           |                             |
> Industrial Linux Solutions                 | http://www.pengutronix.de/  |
> Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
> Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |