[Question] How was zedboard lowlevel written?

[Masahiro Yamada]

Hi Steffen,


On Fri, 09 Jan 2015 10:07:54 +0100
Steffen Trumtrar <s.trumtrar at pengutronix.de> wrote:

> 
> Hi!
> 
> Masahiro Yamada writes:
> > Hello Steffen Trumtrar,
> >
> > I am seeing arch/arm/boards/avnet-zedboard/board.c
> > written by you.
> >
> 
> Sadly it's been a while since I touched this :(
> 
> > Is this file equivalent to ps7_init.c spit by Xilinx tool?
> > Or did you write it by hand from scratch ? (I doubt it.)
> >
> >
> > I have ZC706, another Zynq board.
> > If I could port barebox to this board, that would be great!
> > But I am just worndering whether I could get your advice about
> > how to create the lowlevel file.
> >
> 
> The lowlevel.c/flash_header.c are adapted from the ps7_init code IIRC.
> Xilinx uses a prebootloader and a bootloader for the Zynq, barebox does
> not. So you would have to put all values into the respective two files.
> And you need to run scripts/zynq_mkimage for the checksum (but I think
> the Makefile already does that).
> 
> I wish I could be of more help here, but I can't really remember the
> actual steps necessary and I don't have a ps7_init handy at the moment.
> 

OK, thanks.

I just wanted to be sure in case there were some tools or tips etc.
that would save my time.

Anyway, I will give it a try.



Best Regards
Masahiro Yamada