set root variable for uImage?

[Adam Furmanczuk]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hi,

I restate this question from my previous thread "how to flash and set
root variable". Thanks very much to Sascha and Alexander for
introducing into barebox building and flashing.

I have a basic scenario. Want to boot uImage and then hand over to the
root partition. With u-Boot this was very easy:

setenv bootargs "console=tty0 console=ttymxc0,115200n8
root=/dev/mmcblk0p3 rootfstype=ext4 rootwait ro"

With barebox however, when I boot the uImage, it complains about not
setting correct "root=".:

[ 1.718527] VFS: Cannot open root device "(null)" or
unknown-block(0,0): error -6
[ 1.726226] Please append a correct "root=" boot option; here are the
available partitions:

Now what i do in Barbox is the following;

(hint enter to go into console)
barebox at myhost:/ mkdir /media2
barebox at myhost:/ mount /dev/disk0.1 fat /media2
barebox at myhost:/ bootm /media2/uImage root=/dev/mmcblk0p3 rootfstype=ext4


I get the error with block (0,0). How can I change this? Thank you
very much for help.


Adam
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.12 (GNU/Linux)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org/

iEYEARECAAYFAlHUQYEACgkQefEEI87R1DeRcgCfWcfsNWtj9vEjM+sTmoY/IafD
hssAnRnylX3HQAuvPM/T1TduYZlrz2W2
=Wn6A
-----END PGP SIGNATURE-----