[PATCH 6/7] at91: nand switch ecc base to resource
Jean-Christophe PLAGNIOL-VILLARD
plagnioj at jcrosoft.com
Fri Sep 16 08:23:47 EDT 2011
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj at jcrosoft.com>
---
arch/arm/boards/at91sam9260ek/init.c | 2 --
arch/arm/boards/at91sam9261ek/init.c | 1 -
arch/arm/boards/at91sam9263ek/init.c | 2 --
arch/arm/boards/pm9263/init.c | 2 --
arch/arm/mach-at91/at91sam9260_devices.c | 17 +++++++++++++++--
arch/arm/mach-at91/at91sam9263_devices.c | 17 +++++++++++++++--
arch/arm/mach-at91/at91sam9g45_devices.c | 20 +++++++++++++++-----
arch/arm/mach-at91/include/mach/board.h | 1 -
drivers/mtd/nand/atmel_nand.c | 8 ++++----
9 files changed, 49 insertions(+), 21 deletions(-)
diff --git a/arch/arm/boards/at91sam9260ek/init.c b/arch/arm/boards/at91sam9260ek/init.c
index e4b98bf..8fab557 100644
--- a/arch/arm/boards/at91sam9260ek/init.c
+++ b/arch/arm/boards/at91sam9260ek/init.c
@@ -63,8 +63,6 @@ static struct atmel_nand_data nand_pdata = {
.ale = 21,
.cle = 22,
/* .det_pin = ... not connected */
- .ecc_base = (void __iomem *)(AT91_BASE_SYS + AT91_ECC),
- .ecc_mode = NAND_ECC_SOFT,
.rdy_pin = AT91_PIN_PC13,
.enable_pin = AT91_PIN_PC14,
#if defined(CONFIG_MTD_NAND_ATMEL_BUSWIDTH_16)
diff --git a/arch/arm/boards/at91sam9261ek/init.c b/arch/arm/boards/at91sam9261ek/init.c
index 73b411a..69111a0 100644
--- a/arch/arm/boards/at91sam9261ek/init.c
+++ b/arch/arm/boards/at91sam9261ek/init.c
@@ -43,7 +43,6 @@ static struct atmel_nand_data nand_pdata = {
.ale = 22,
.cle = 21,
/* .det_pin = ... not connected */
- .ecc_mode = NAND_ECC_SOFT,
.rdy_pin = AT91_PIN_PC15,
.enable_pin = AT91_PIN_PC14,
#if defined(CONFIG_MTD_NAND_ATMEL_BUSWIDTH_16)
diff --git a/arch/arm/boards/at91sam9263ek/init.c b/arch/arm/boards/at91sam9263ek/init.c
index 9e0981f..278e312 100644
--- a/arch/arm/boards/at91sam9263ek/init.c
+++ b/arch/arm/boards/at91sam9263ek/init.c
@@ -44,8 +44,6 @@ static struct atmel_nand_data nand_pdata = {
.ale = 21,
.cle = 22,
/* .det_pin = ... not connected */
- .ecc_base = (void __iomem *)(AT91_BASE_SYS + AT91_ECC0),
- .ecc_mode = NAND_ECC_SOFT,
.rdy_pin = AT91_PIN_PA22,
.enable_pin = AT91_PIN_PD15,
#if defined(CONFIG_MTD_NAND_ATMEL_BUSWIDTH_16)
diff --git a/arch/arm/boards/pm9263/init.c b/arch/arm/boards/pm9263/init.c
index a1fe0cd..8f451e8 100644
--- a/arch/arm/boards/pm9263/init.c
+++ b/arch/arm/boards/pm9263/init.c
@@ -43,8 +43,6 @@ static struct atmel_nand_data nand_pdata = {
.ale = 21,
.cle = 22,
/* .det_pin = ... not connected */
- .ecc_base = (void __iomem *)(AT91_BASE_SYS + AT91_ECC0),
- .ecc_mode = NAND_ECC_SOFT,
.rdy_pin = AT91_PIN_PB30,
.enable_pin = AT91_PIN_PD15,
#if defined(CONFIG_MTD_NAND_ATMEL_BUSWIDTH_16)
diff --git a/arch/arm/mach-at91/at91sam9260_devices.c b/arch/arm/mach-at91/at91sam9260_devices.c
index 4540f4b..4607646 100644
--- a/arch/arm/mach-at91/at91sam9260_devices.c
+++ b/arch/arm/mach-at91/at91sam9260_devices.c
@@ -63,6 +63,19 @@ void at91_add_device_eth(struct at91_ether_platform_data *data) {}
#endif
#if defined(CONFIG_NAND_ATMEL)
+static struct resource nand_resources[] = {
+ [0] = {
+ .start = AT91_CHIPSELECT_3,
+ .size = SZ_256M,
+ .flags = IORESOURCE_MEM,
+ },
+ [1] = {
+ .start = AT91_BASE_SYS + AT91_ECC,
+ .size = 512,
+ .flags = IORESOURCE_MEM,
+ }
+};
+
void at91_add_device_nand(struct atmel_nand_data *data)
{
unsigned long csa;
@@ -85,8 +98,8 @@ void at91_add_device_nand(struct atmel_nand_data *data)
if (data->det_pin)
at91_set_gpio_input(data->det_pin, 1);
- add_generic_device("atmel_nand", 0, NULL, AT91_CHIPSELECT_3, 0x10,
- IORESOURCE_MEM, data);
+ add_generic_device_res("atmel_nand", 0, nand_resources,
+ ARRAY_SIZE(nand_resources), data);
}
#else
void at91_add_device_nand(struct atmel_nand_data *data) {}
diff --git a/arch/arm/mach-at91/at91sam9263_devices.c b/arch/arm/mach-at91/at91sam9263_devices.c
index c7ae45a..f5058dc 100644
--- a/arch/arm/mach-at91/at91sam9263_devices.c
+++ b/arch/arm/mach-at91/at91sam9263_devices.c
@@ -62,6 +62,19 @@ void at91_add_device_eth(struct at91_ether_platform_data *data) {}
#endif
#if defined(CONFIG_NAND_ATMEL)
+static struct resource nand_resources[] = {
+ [0] = {
+ .start = AT91_CHIPSELECT_3,
+ .size = SZ_256M,
+ .flags = IORESOURCE_MEM,
+ },
+ [1] = {
+ .start = AT91_BASE_SYS + AT91_ECC0,
+ .size = 512,
+ .flags = IORESOURCE_MEM,
+ }
+};
+
void at91_add_device_nand(struct atmel_nand_data *data)
{
unsigned long csa;
@@ -84,8 +97,8 @@ void at91_add_device_nand(struct atmel_nand_data *data)
if (data->det_pin)
at91_set_gpio_input(data->det_pin, 1);
- add_generic_device("atmel_nand", -1, NULL, AT91_CHIPSELECT_3, 0x10,
- IORESOURCE_MEM, data);
+ add_generic_device_res("atmel_nand", -1, nand_resources,
+ ARRAY_SIZE(nand_resources), data);
}
#else
void at91_add_device_nand(struct atmel_nand_data *data) {}
diff --git a/arch/arm/mach-at91/at91sam9g45_devices.c b/arch/arm/mach-at91/at91sam9g45_devices.c
index e18682b..8bc1104 100644
--- a/arch/arm/mach-at91/at91sam9g45_devices.c
+++ b/arch/arm/mach-at91/at91sam9g45_devices.c
@@ -63,6 +63,19 @@ void at91_add_device_eth(struct at91_ether_platform_data *data) {}
#endif
#if defined(CONFIG_NAND_ATMEL)
+static struct resource nand_resources[] = {
+ [0] = {
+ .start = AT91_CHIPSELECT_3,
+ .size = SZ_256M,
+ .flags = IORESOURCE_MEM,
+ },
+ [1] = {
+ .start = AT91_BASE_SYS + AT91_ECC,
+ .size = 512,
+ .flags = IORESOURCE_MEM,
+ }
+};
+
void at91_add_device_nand(struct atmel_nand_data *data)
{
unsigned long csa;
@@ -70,9 +83,6 @@ void at91_add_device_nand(struct atmel_nand_data *data)
if (!data)
return;
- data->ecc_base = (void __iomem *)(AT91_BASE_SYS + AT91_ECC);
- data->ecc_mode = NAND_ECC_SOFT;
-
csa = at91_sys_read(AT91_MATRIX_EBICSA);
at91_sys_write(AT91_MATRIX_EBICSA, csa | AT91_MATRIX_EBI_CS3A_SMC_SMARTMEDIA);
@@ -88,8 +98,8 @@ void at91_add_device_nand(struct atmel_nand_data *data)
if (data->det_pin)
at91_set_gpio_input(data->det_pin, 1);
- add_generic_device("atmel_nand", -1, NULL, AT91_CHIPSELECT_3, 0x10,
- IORESOURCE_MEM, data);
+ add_generic_device_res("atmel_nand", -1, nand_resources,
+ ARRAY_SIZE(nand_resources), data);
}
#else
void at91_add_device_nand(struct atmel_nand_data *data) {}
diff --git a/arch/arm/mach-at91/include/mach/board.h b/arch/arm/mach-at91/include/mach/board.h
index 2adc035..f970ad8 100644
--- a/arch/arm/mach-at91/include/mach/board.h
+++ b/arch/arm/mach-at91/include/mach/board.h
@@ -29,7 +29,6 @@ void atmel_nand_load_image(void *dest, int size, int pagesize, int blocksize);
/* NAND / SmartMedia */
struct atmel_nand_data {
- void __iomem *ecc_base;
u8 enable_pin; /* chip enable */
u8 det_pin; /* card detect */
u8 rdy_pin; /* ready/busy */
diff --git a/drivers/mtd/nand/atmel_nand.c b/drivers/mtd/nand/atmel_nand.c
index f79be9a..0710407 100644
--- a/drivers/mtd/nand/atmel_nand.c
+++ b/drivers/mtd/nand/atmel_nand.c
@@ -399,13 +399,13 @@ static int __init atmel_nand_probe(struct device_d *dev)
if (host->board->rdy_pin)
nand_chip->dev_ready = atmel_nand_device_ready;
- nand_chip->ecc.mode = pdata->ecc_mode;
+ nand_chip->ecc.mode = NAND_ECC_SOFT;
if (pdata->ecc_mode == NAND_ECC_HW) {
- if (!pdata->ecc_base)
- return -ENODEV;
+ host->ecc = dev_request_mem_region(dev, 1);
- host->ecc = pdata->ecc_base;
+ if (!host->ecc)
+ return -ENODEV;
nand_chip->ecc.mode = NAND_ECC_HW;
nand_chip->ecc.calculate = atmel_nand_calculate;
--
1.7.5.4
More information about the barebox
mailing list