booting pandaboard rev A2 problems

Sascha Hauer s.hauer at pengutronix.de
Mon Jun 20 03:04:58 EDT 2011


Hi Marek,

On Fri, Jun 17, 2011 at 09:26:46PM +0200, Belisko Marek wrote:
> Hi,
> 
> I'm trying to boot barebox on Panda rev. A2.

Hm, I don't know the revision of our panda board. I'll have a look
later, it may be different.

> 
> I make panda_xload_defconfig compile and put to FAT SD card partition
> ranamed barebox.bin to u-boot.bin (MLO reads u-boot.bin by default).

I'm a bit confused. The binary resulting from xload_defconfig is
supposed to replace MLO.  There are two panda defconfig in the tree, one
for xloader replacement and one regular full blown config.

> 
> Barebox start but after printing revision number is stuck. I add some
> printks and
> seems it hang in omap_hsmmc_probe funtion after mci_register(&hsmmc->mci) call.
> 
> I try with 2 SD cards and non of them is working.
> 
> Also try to load to flash partition only barebox.bin.itf + barebox.bin
> but this setup also
> doesn't work. AFAIU itf add some data before barebox to be possible to
> boot directly without
> x-loader. When run_shell is called barebox.bin should be copied do
> DDRAM and run.

Ok, let's try to sort things a bit.
does panda_xload_defconfig barebox.bin.itf copied as MLO to the SD card
produce any output?
Does panda_defconfig copied as u-boot.bin to the SD card work or does it
behave like you described above?

Sascha

-- 
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |



More information about the barebox mailing list