booting pandaboard rev A2 problems

[Belisko Marek]

Hi,

I'm trying to boot barebox on Panda rev. A2.

I make panda_xload_defconfig compile and put to FAT SD card partition
ranamed barebox.bin to u-boot.bin (MLO reads u-boot.bin by default).

Barebox start but after printing revision number is stuck. I add some
printks and
seems it hang in omap_hsmmc_probe funtion after mci_register(&hsmmc->mci) call.

I try with 2 SD cards and non of them is working.

Also try to load to flash partition only barebox.bin.itf + barebox.bin
but this setup also
doesn't work. AFAIU itf add some data before barebox to be possible to
boot directly without
x-loader. When run_shell is called barebox.bin should be copied do
DDRAM and run.

Any ideas what should I check.

Thanks in advance,

marek


-- 
as simple and primitive as possible
-------------------------------------------------
Marek Belisko - OPEN-NANDRA
Freelance Developer

Ruska Nova Ves 219 | Presov, 08005 Slovak Republic
Tel: +421 915 052 184
skype: marekwhite
icq: 290551086
web: http://open-nandra.com