/dev/env0 not found

[Jean-Christophe PLAGNIOL-VILLARD]

On 14:26 Fri 14 Jan     , Sascha Hauer wrote:
> Hi Nataraj,
> 
> On Fri, Jan 14, 2011 at 12:01:25PM +0000, Nataraj S Narayan wrote:
> > Hi
> > 
> > How I come I don't have /dev/env0? I am on at91sam9263ek.
> > 
> > 9263-EK:/ saveenv
> > saving environment
> > could not open /dev/env0: Read-only file system
> > 
> > 9263-EK:/ ls -l /dev/env0
> > ls: /dev/env0: No such file or directory
> > 
> > 9263-EK:/ ls -l /dev/
> > cr-------- 4294967295 zero
> > crw-------       3785 defaultenv
> > crw------- 4294967295 mem
> > crw-------   67108864 ram0
> > crw-------  268435456 nand0
> > cr--------    8388608 nand_oob0
> > crw-------         32 phy0
> > crw------- 3851423744 nor-352321538
>                            ^^^^^^^^^^
> 
> This should normally be nor0. The name comes from
> info->cdev.name = asprintf("nor%d", dev->id);
> in cfi_probe. dev->id is normally initialized to -1 in
> arch/arm/boards/at91sam9263ek/init.c, then changed to 0 in
> register_device:
> 
> 	if (new_device->id < 0) {
> 		new_device->id = get_free_deviceid(new_device->name);
> 	}
> ...
> 
> I have no idea why this does not work in your case, so it's maybe best
> to add some printfs in the path I just described to see where dev->id is
> actually changed to such a bogus value.
> 
> Note that on the at91sam9263ek the environment partition is added as
> follows:
> 
> #if defined(CONFIG_DRIVER_CFI) || defined(CONFIG_DRIVER_CFI_OLD)
> 	devfs_add_partition("nor0", 0x00000, 0x40000, PARTITION_FIXED, "self");
> 	devfs_add_partition("nor0", 0x40000, 0x20000, PARTITION_FIXED, "env0");
> #elif defined(CONFIG_NAND_ATMEL)
> 	devfs_add_partition("nand0", 0x00000, 0x80000, PARTITION_FIXED, "self_raw");
> 	dev_add_bb_dev("self_raw", "self0");
> 	devfs_add_partition("nand0", 0x40000, 0x40000, PARTITION_FIXED, "env_raw");
> 	dev_add_bb_dev("env_raw", "env0");
> #endif
> 
> This means that when both nand and nor flash is compiled in the
> environment which be in nor flash. On i.MX we have a way to figure out
> if barebox is started from nor or from nand and locate the environment
> in the same device as barebox is started from. I don't know if that's
> possible on the Atmel processors though.
unfortunatly no

:(

Best Regards,
J.